Personnel and Material Decontamination Equipment

Automatic Two-Hand Sanitizer Dispenser

An enclosed dispenser that treats both hands with a metered sanitizer spray after the user places them in separate hand ports.

Simultaneous two-hand positioning
Enclosed spray hand ports
Touchless presence sensing
Cycle-completion output

Request a Quote Browse Products

Product Introduction

The Automatic Two-Hand Sanitizer Dispenser uses two enclosed hand ports to position both hands before a metered sanitizer spray is released. Optical sensing can prevent dispensing until both ports are occupied, while the enclosed geometry directs excess liquid to a removable drip tray. A dry-contact output can be used by connected equipment after the programmed dispense cycle is complete.

Key Features

Separate ports guide the user to position both hands for the programmed cycle.

Opposed nozzles can apply the selected sanitizer around the intended hand area.

Optical sensing avoids the need for a shared activation button.

An enclosed port geometry contains overspray above a removable drip tray.

A completion output can be made available to compatible external control equipment.

Customer Product Concerns

A wall-mounted pump dispenser cannot confirm two-hand positioning or contain excess liquid at a busy entry route.

A single hand pump dose may be applied inconsistently.The two-port arrangement uses metered nozzles after both hands are positioned.

Users activate a dispenser with one hand and continue through the entrance.Sensors can require both hand ports to be occupied before the cycle begins.

Spray from an open dispenser reaches the floor below it.Enclosed hand ports direct excess liquid to a removable drip tray.

Connected entry equipment needs a signal only after dispensing is complete.The controller can provide a dry-contact completion output at the end of the programmed cycle.

Typical Applications

Food production hygiene barriersCleanroom personnel entriesPharmaceutical support areasMedical manufacturing changing roomsControlled packaging access

Technical Parameters

Cabinet format, hand-port geometry and solution-reservoir arrangement can be selected for the entrance layout and chosen sanitizer.

Core Material	Chemical-resistant polyethylene fluid lines in a SUS304 enclosure
Panel Thickness	1.2–1.5 mm stainless steel enclosure panels
Effective Width	350–600 mm operator access width
Maximum Length	500–900 mm overall dispenser height
Steel Facing Thickness	1.2–1.5 mm SUS304
Core Density	930–960 kg/m³ for polyethylene fluid components
Thermal Conductivity	0.40–0.50 W/(m·K) for polyethylene fluid components
Surface Finish	Brushed SUS304 with chemical-resistant hand ports and drip tray
Joint Type	Sealed dispenser cabinet with removable reservoir and drain-tray connections
Customization	Available based on the intended application and operating environment.

Available Options

Pedestal or wall-mounted bodyReservoir level alarmChoice of hand-port orientationExternal completion relay

Planning a Automatic Two-Hand Sanitizer Dispenser specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team