Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Equipamento de manuseio de ar e HVAC para sala limpa
Unidade compacta de manuseio de ar
A factory-assembled short-footprint air handler that integrates essential filtration, coil and fan functions for smaller controlled spaces.
- Short Equipment Footprint
- Factory-Assembled Package
- Integrated Controls
- Accessible Service Side
Introdução do produto
The compact air handling unit combines closely matched filters, coil and direct-drive fan in a monobloc or two-section casing. Component spacing is optimized to reduce overall length while maintaining coil drainage and filter removal. Integrated controls can manage fan speed, valve output, frost protection and filter alarms. The package suits smaller clean support rooms and retrofit locations where a full modular AHU would occupy excessive plant space.
Características-chave
Factory-installed controls simplify fan, coil and frost-protection integration.
Direct-drive fans eliminate belt clearance and reduce maintenance inside the compact casing.
Multiple duct orientations help the unit fit above, beside or behind existing services.
Preocupações do produto do cliente
Compact equipment must save space without compressing filters, drains and service points until maintenance becomes impractical.
A conventional modular AHU is longer than the available mechanical room.Close-coupled components and a direct-drive fan shorten the casing.
Filter removal collides with nearby pipework.The service side and pull direction are selected to match the actual clear zone.
Condensate is drawn off the coil because the fan is too close.A sized separation space and sloped drain pan preserve moisture control.
Field-mounted controls occupy additional wall and wiring space.A unit-mounted controller and sensors centralize the operating package.
Aplicações típicas
Small cleanroom suitesSalas de suporte de laboratórioÁreas de inspeção de dispositivos médicosControlled storage spacesRetrofit ventilation systems
Parâmetros técnicos
Typical construction ranges for a compact insulated air handler are listed below.
| Material principal | Closed-cell polyurethane or mineral-wool insulation in compact double-skin casing |
|---|---|
| Painel de espessura | 25–50 mm insulated panel |
| Largura efetiva | 600–1800 mm nominal casing width |
| Comprimento máximo | Up to 4500 mm complete assembled length |
| Aço enfrentando espessura | 0.6–0.8 mm galvanized or coated sheet skins |
| Densidade Core | 38–42 kg/m³ polyurethane or 60–85 kg/m³ mineral wool |
| Condutividade térmica | 0.023–0.040 W/(m·K) depending on insulation |
| Superfície acabado | Powder-coated galvanized exterior with smooth galvanized inner surfaces |
| Tipo conjunto | Gasketed monobloc or two-section casing with removable service panels |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Horizontal, vertical or top-connected casingChilled-water or DX coolingEC fan and integrated controllerPlate or rotary heat-recovery section
Planning a Compact Air Handling Unit specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
