Compact air handling unit with short insulated casing

クリーンルーム HVAC および空気処理装置

コンパクトな空気取扱ユニット

A factory-assembled short-footprint air handler that integrates essential filtration, coil and fan functions for smaller controlled spaces.

Short Equipment Footprint
Factory-Assembled Package
Integrated Controls
Accessible Service Side

見積もりリクエスト製品案内

商品紹介

The compact air handling unit combines closely matched filters, coil and direct-drive fan in a monobloc or two-section casing. Component spacing is optimized to reduce overall length while maintaining coil drainage and filter removal. Integrated controls can manage fan speed, valve output, frost protection and filter alarms. The package suits smaller clean support rooms and retrofit locations where a full modular AHU would occupy excessive plant space.

主要な特徴

Close-coupled treatment sections reduce plant-room footprint without removing essential service access.

Factory-installed controls simplify fan, coil and frost-protection integration.

Direct-drive fans eliminate belt clearance and reduce maintenance inside the compact casing.

Multiple duct orientations help the unit fit above, beside or behind existing services.

お客様の製品に関する懸念事項

Compact equipment must save space without compressing filters, drains and service points until maintenance becomes impractical.

A conventional modular AHU is longer than the available mechanical room.Close-coupled components and a direct-drive fan shorten the casing.

Filter removal collides with nearby pipework.The service side and pull direction are selected to match the actual clear zone.

Condensate is drawn off the coil because the fan is too close.A sized separation space and sloped drain pan preserve moisture control.

Field-mounted controls occupy additional wall and wiring space.A unit-mounted controller and sensors centralize the operating package.

典型的な用途

Small cleanroom suites研究室サポートルーム医療機器検査エリアControlled storage spacesRetrofit ventilation systems

技術的なパラメータ

Typical construction ranges for a compact insulated air handler are listed below.

コア材料	Closed-cell polyurethane or mineral-wool insulation in compact double-skin casing
パネルの厚さ	25–50 mm insulated panel
有効幅	600–1800 mm nominal casing width
最大長さ	Up to 4500 mm complete assembled length
鋼鉄の厚さを直面する	0.6–0.8 mm galvanized or coated sheet skins
コア密度	38–42 kg/m³ polyurethane or 60–85 kg/m³ mineral wool
熱伝導率	0.023–0.040 W/(m·K) depending on insulation
表面仕上げ	Powder-coated galvanized exterior with smooth galvanized inner surfaces
ジョイントタイプ	Gasketed monobloc or two-section casing with removable service panels
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Horizontal, vertical or top-connected casingChilled-water or DX coolingEC fan and integrated controllerPlate or rotary heat-recovery section

Planning a Compact Air Handling Unit specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する