Bahasa Inggris
Bahasa Jerman
Bahasa Arab
Bahasa Perancis: Bahasa Perancis
Bahasa IndonesiaSaat ini
Bahasa Jepang
Bahasa Korea
Bahasa Melayu
Bahasa Portugis
Bahasa Rusia
Bahasa Spanyol
Bahasa Thailand
Bahasa Turki
Bahasa Vietnam
Cleanroom HVAC dan Peralatan Penanganan Udara
Unit Penanganan Udara Kompak (Compact Air Handling Unit)
A factory-assembled short-footprint air handler that integrates essential filtration, coil and fan functions for smaller controlled spaces.
- Short Equipment Footprint
- Factory-Assembled Package
- Integrated Controls
- Accessible Service Side
Perkenalan produk
The compact air handling unit combines closely matched filters, coil and direct-drive fan in a monobloc or two-section casing. Component spacing is optimized to reduce overall length while maintaining coil drainage and filter removal. Integrated controls can manage fan speed, valve output, frost protection and filter alarms. The package suits smaller clean support rooms and retrofit locations where a full modular AHU would occupy excessive plant space.
Fitur utama:
Factory-installed controls simplify fan, coil and frost-protection integration.
Direct-drive fans eliminate belt clearance and reduce maintenance inside the compact casing.
Multiple duct orientations help the unit fit above, beside or behind existing services.
Kekhawatiran produk pelanggan
Compact equipment must save space without compressing filters, drains and service points until maintenance becomes impractical.
A conventional modular AHU is longer than the available mechanical room.Close-coupled components and a direct-drive fan shorten the casing.
Filter removal collides with nearby pipework.The service side and pull direction are selected to match the actual clear zone.
Condensate is drawn off the coil because the fan is too close.A sized separation space and sloped drain pan preserve moisture control.
Field-mounted controls occupy additional wall and wiring space.A unit-mounted controller and sensors centralize the operating package.
Aplikasi yang Tipis
Small cleanroom suitesRuang dukungan laboratoriumArea inspeksi perangkat medisControlled storage spacesRetrofit ventilation systems
Parameter teknis
Typical construction ranges for a compact insulated air handler are listed below.
| Bahan inti | Closed-cell polyurethane or mineral-wool insulation in compact double-skin casing |
|---|---|
| Ketebalan Panel (Panel Thickness) | 25–50 mm insulated panel |
| Efektif lebar | 600–1800 mm nominal casing width |
| Panjang maksimum | Up to 4500 mm complete assembled length |
| Baja menghadap ketebalan | 0.6–0.8 mm galvanized or coated sheet skins |
| Kepadatan inti (core density) | 38–42 kg/m³ polyurethane or 60–85 kg/m³ mineral wool |
| Konduktivitas Termal (Thermal Conductivity) | 0.023–0.040 W/(m·K) depending on insulation |
| Permukaan selesai | Powder-coated galvanized exterior with smooth galvanized inner surfaces |
| Jenis Bersama | Gasketed monobloc or two-section casing with removable service panels |
| Customization (Kustomisasi) | Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi. |
Pilihan yang tersedia
Horizontal, vertical or top-connected casingChilled-water or DX coolingEC fan and integrated controllerPlate or rotary heat-recovery section
Planning a Compact Air Handling Unit specification?
Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.
