Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Salle blanche HVAC et équipement de manutention de l'air
Unité de manutention d'air compacte
A factory-assembled short-footprint air handler that integrates essential filtration, coil and fan functions for smaller controlled spaces.
- Short Equipment Footprint
- Factory-Assembled Package
- Integrated Controls
- Accessible Service Side
Introduction de produit
The compact air handling unit combines closely matched filters, coil and direct-drive fan in a monobloc or two-section casing. Component spacing is optimized to reduce overall length while maintaining coil drainage and filter removal. Integrated controls can manage fan speed, valve output, frost protection and filter alarms. The package suits smaller clean support rooms and retrofit locations where a full modular AHU would occupy excessive plant space.
Key Features
Factory-installed controls simplify fan, coil and frost-protection integration.
Direct-drive fans eliminate belt clearance and reduce maintenance inside the compact casing.
Multiple duct orientations help the unit fit above, beside or behind existing services.
Préoccupations du client produit
Compact equipment must save space without compressing filters, drains and service points until maintenance becomes impractical.
A conventional modular AHU is longer than the available mechanical room.Close-coupled components and a direct-drive fan shorten the casing.
Filter removal collides with nearby pipework.The service side and pull direction are selected to match the actual clear zone.
Condensate is drawn off the coil because the fan is too close.A sized separation space and sloped drain pan preserve moisture control.
Field-mounted controls occupy additional wall and wiring space.A unit-mounted controller and sensors centralize the operating package.
Les applications typiques
Small cleanroom suitesSalles de soutien de laboratoireZones d'inspection des dispositifs médicaux
parControlled storage spacesRetrofit ventilation systems
Paramètres techniques
Typical construction ranges for a compact insulated air handler are listed below.
| Matériaux de base | Closed-cell polyurethane or mineral-wool insulation in compact double-skin casing |
|---|---|
| Panneau épaisseur | 25–50 mm insulated panel |
| Largeur effective | 600–1800 mm nominal casing width |
| Longueur maximale | Up to 4500 mm complete assembled length |
| Acier face épaisseur | 0.6–0.8 mm galvanized or coated sheet skins |
| Densité Core | 38–42 kg/m³ polyurethane or 60–85 kg/m³ mineral wool |
| Conductivité thermique | 0.023–0.040 W/(m·K) depending on insulation |
| surface finie | Powder-coated galvanized exterior with smooth galvanized inner surfaces |
| Type joint | Gasketed monobloc or two-section casing with removable service panels |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
Horizontal, vertical or top-connected casingChilled-water or DX coolingEC fan and integrated controllerPlate or rotary heat-recovery section
Planning a Compact Air Handling Unit specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
