Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Equipos de HVAC y manejo de aire para salas limpias
Unidad de manejo de aire compacta
A factory-assembled short-footprint air handler that integrates essential filtration, coil and fan functions for smaller controlled spaces.
- Short Equipment Footprint
- Factory-Assembled Package
- Integrated Controls
- Accessible Service Side
Introducción del producto
The compact air handling unit combines closely matched filters, coil and direct-drive fan in a monobloc or two-section casing. Component spacing is optimized to reduce overall length while maintaining coil drainage and filter removal. Integrated controls can manage fan speed, valve output, frost protection and filter alarms. The package suits smaller clean support rooms and retrofit locations where a full modular AHU would occupy excessive plant space.
Características clave
Factory-installed controls simplify fan, coil and frost-protection integration.
Direct-drive fans eliminate belt clearance and reduce maintenance inside the compact casing.
Multiple duct orientations help the unit fit above, beside or behind existing services.
Preocupaciones del producto del cliente
Compact equipment must save space without compressing filters, drains and service points until maintenance becomes impractical.
A conventional modular AHU is longer than the available mechanical room.Close-coupled components and a direct-drive fan shorten the casing.
Filter removal collides with nearby pipework.The service side and pull direction are selected to match the actual clear zone.
Condensate is drawn off the coil because the fan is too close.A sized separation space and sloped drain pan preserve moisture control.
Field-mounted controls occupy additional wall and wiring space.A unit-mounted controller and sensors centralize the operating package.
Aplicaciones típicas
Small cleanroom suitesSalas de apoyo de laboratorioÁreas de inspección de dispositivos médicosControlled storage spacesRetrofit ventilation systems
Parámetros técnicos
Typical construction ranges for a compact insulated air handler are listed below.
| Materiales Core | Closed-cell polyurethane or mineral-wool insulation in compact double-skin casing |
|---|---|
| Panel de espesor | 25–50 mm insulated panel |
| Ancho efectivo | 600–1800 mm nominal casing width |
| Longitud máxima | Up to 4500 mm complete assembled length |
| Acero frente a espesor | 0.6–0.8 mm galvanized or coated sheet skins |
| Densidad Core | 38–42 kg/m³ polyurethane or 60–85 kg/m³ mineral wool |
| Conductividad térmica | 0.023–0.040 W/(m·K) depending on insulation |
| Superficie acabada | Powder-coated galvanized exterior with smooth galvanized inner surfaces |
| Tipo conjunto | Gasketed monobloc or two-section casing with removable service panels |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Opciones disponibles
Horizontal, vertical or top-connected casingChilled-water or DX coolingEC fan and integrated controllerPlate or rotary heat-recovery section
Planning a Compact Air Handling Unit specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
