Compact air handling unit with short insulated casing

Bilik Bersih HVAC dan Peralatan Pengendalian Udara

Unit Pengendalian Udara Kompak

A factory-assembled short-footprint air handler that integrates essential filtration, coil and fan functions for smaller controlled spaces.

Short Equipment Footprint
Factory-Assembled Package
Integrated Controls
Accessible Service Side

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The compact air handling unit combines closely matched filters, coil and direct-drive fan in a monobloc or two-section casing. Component spacing is optimized to reduce overall length while maintaining coil drainage and filter removal. Integrated controls can manage fan speed, valve output, frost protection and filter alarms. The package suits smaller clean support rooms and retrofit locations where a full modular AHU would occupy excessive plant space.

Ciri-ciri Utama

Close-coupled treatment sections reduce plant-room footprint without removing essential service access.

Factory-installed controls simplify fan, coil and frost-protection integration.

Direct-drive fans eliminate belt clearance and reduce maintenance inside the compact casing.

Multiple duct orientations help the unit fit above, beside or behind existing services.

Kebimbangan Produk Pelanggan

Compact equipment must save space without compressing filters, drains and service points until maintenance becomes impractical.

A conventional modular AHU is longer than the available mechanical room.Close-coupled components and a direct-drive fan shorten the casing.

Filter removal collides with nearby pipework.The service side and pull direction are selected to match the actual clear zone.

Condensate is drawn off the coil because the fan is too close.A sized separation space and sloped drain pan preserve moisture control.

Field-mounted controls occupy additional wall and wiring space.A unit-mounted controller and sensors centralize the operating package.

Permohonan yang biasa

Small cleanroom suitesBilik sokongan makmalKawasan pemeriksaan peranti perubatanControlled storage spacesRetrofit ventilation systems

Parameter teknikal

Typical construction ranges for a compact insulated air handler are listed below.

Bahan Teras	Closed-cell polyurethane or mineral-wool insulation in compact double-skin casing
Ketebalan Panel	25–50 mm insulated panel
Lebar berkesan	600–1800 mm nominal casing width
Panjang maksimum	Up to 4500 mm complete assembled length
Keluli Menghadapi Ketebalan	0.6–0.8 mm galvanized or coated sheet skins
Ketumpatan teras	38–42 kg/m³ polyurethane or 60–85 kg/m³ mineral wool
Kekonduksian Terma	0.023–0.040 W/(m·K) depending on insulation
Kemasan permukaan	Powder-coated galvanized exterior with smooth galvanized inner surfaces
Jenis Bersatu	Gasketed monobloc or two-section casing with removable service panels
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

Horizontal, vertical or top-connected casingChilled-water or DX coolingEC fan and integrated controllerPlate or rotary heat-recovery section

Planning a Compact Air Handling Unit specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami