İngilizce
Almanca
Arapça
Fransızca
Endonezya dilinde
Japonca
Korece
Malay dilinde
Portekizce
Rusça
İspanyolca
Taylandca
TürkçeCurrent
Vietnamca
Temiz Oda HVAC ve Hava İşleme Ekipmanları
Compact Air Handling Unit (Kompakt Hava İşlem Birimi)
A factory-assembled short-footprint air handler that integrates essential filtration, coil and fan functions for smaller controlled spaces.
- Short Equipment Footprint
- Factory-Assembled Package
- Integrated Controls
- Accessible Service Side
Ürün tanıtımı
The compact air handling unit combines closely matched filters, coil and direct-drive fan in a monobloc or two-section casing. Component spacing is optimized to reduce overall length while maintaining coil drainage and filter removal. Integrated controls can manage fan speed, valve output, frost protection and filter alarms. The package suits smaller clean support rooms and retrofit locations where a full modular AHU would occupy excessive plant space.
Ana Özellikler
Factory-installed controls simplify fan, coil and frost-protection integration.
Direct-drive fans eliminate belt clearance and reduce maintenance inside the compact casing.
Multiple duct orientations help the unit fit above, beside or behind existing services.
Müşteri Ürün Sorunları
Compact equipment must save space without compressing filters, drains and service points until maintenance becomes impractical.
A conventional modular AHU is longer than the available mechanical room.Close-coupled components and a direct-drive fan shorten the casing.
Filter removal collides with nearby pipework.The service side and pull direction are selected to match the actual clear zone.
Condensate is drawn off the coil because the fan is too close.A sized separation space and sloped drain pan preserve moisture control.
Field-mounted controls occupy additional wall and wiring space.A unit-mounted controller and sensors centralize the operating package.
Tipik uygulamalar
Small cleanroom suitesLaboratory support roomsTıbbi cihaz denetimi alanlarıControlled storage spacesRetrofit ventilation systems
Teknik parametreler
Typical construction ranges for a compact insulated air handler are listed below.
| Temel malzemeler | Closed-cell polyurethane or mineral-wool insulation in compact double-skin casing |
|---|---|
| Panel kalınlığı | 25–50 mm insulated panel |
| Effective Width (Etkili Genişlik) | 600–1800 mm nominal casing width |
| Maksimum uzunluk | Up to 4500 mm complete assembled length |
| Çelik yüz yüze kalınlığı | 0.6–0.8 mm galvanized or coated sheet skins |
| Core Density (Çekirdek Yoğunluğu) | 38–42 kg/m³ polyurethane or 60–85 kg/m³ mineral wool |
| Termal İletkenlik | 0.023–0.040 W/(m·K) depending on insulation |
| Yüzey bitirme | Powder-coated galvanized exterior with smooth galvanized inner surfaces |
| Ortak tip | Gasketed monobloc or two-section casing with removable service panels |
| Customization (Özelleşme) | Kullanılan uygulama ve çalışma ortamına göre kullanılabilir. |
Mevcut Seçenekler
Horizontal, vertical or top-connected casingChilled-water or DX coolingEC fan and integrated controllerPlate or rotary heat-recovery section
Planning a Compact Air Handling Unit specification?
Bize boyutlarınızı, montaj koşullarınızı, performans hedeflerinizi ve gerekli yüzey kaplamalarınızı gönderin.
