EnglishCurrent
德语
阿拉伯语
法语
印尼语
日语
韩语
马来语
葡萄牙语
俄语
西班牙语
泰语
土耳其语
越南语
Cleanroom Garments, PPE and Consumables
Cleanroom Apron
A lightweight low-lint cleanroom apron providing targeted front-torso and leg coverage with adjustable ties.
- Shin-length low-lint front coverage
- Adjustable neck and waist ties
- Disposable or reusable material options
Product Introduction
The Cleanroom Apron is a simple over-garment for tasks that need additional front-surface coverage without a full garment change. Its one-piece bib, smooth front panel, adjustable neck loop and long waist ties minimize hardware and allow quick donning. White flash-spun polyethylene, film-coated material or reusable polyester can be selected to suit handling and processing needs.
Key Features
Shin-length format extends coverage below the workbench edge
Adjustable neck loop accommodates different operator heights
Long waist ties secure the apron without exposed metal hardware
Smooth pocket-free surface simplifies controlled handling
Customer Product Concerns
An apron provides partial rather than full-body coverage. Material selection, gown overlap and disposal or laundering procedures must therefore match the actual task and the base garment worn underneath.
A short apron may leave the lower torso or upper legs exposed.Select shin-length coverage and suitable width for the operator and work posture.
Fixed neck dimensions can place the bib too high or low.Use an adjustable neck loop and long rear waist ties for controlled positioning.
Pockets and bulky fasteners can trap residues and particles.Specify a smooth pocket-free front with minimal seam count and no exposed hardware.
The apron material may not match the intended splash or ESD requirement.Choose the exact nonwoven, film-coated or conductive polyester construction based on task data.
Typical Applications
Used for controlled dispensing, clean packing, laboratory preparation, equipment wipe-down, visitor protection and other front-facing tasks where local gowning rules permit partial over-garment coverage.
Technical Parameters
These configurable dimensions describe a cleanroom apron, not a full protective garment. Final material and coverage must be selected after reviewing the base gowning system and process exposure.
| Core Material | Flash-spun polyethylene, low-lint film or continuous-filament polyester |
|---|---|
| Panel Thickness | 0.14–0.35 mm |
| Effective Width | 650–900 mm |
| Maximum Length | 1250 mm |
| Steel Facing Thickness | 0 mm; no steel facing used |
| Core Density | 45–125 kg/m³ apparent material bulk density |
| Thermal Conductivity | 0.035–0.060 W/(m·K), material dependent |
| Surface Finish | Smooth low-lint white or light-blue surface without pockets |
| Joint Type | One-piece front panel with sewn or bonded neck and waist ties |
| Customization | Available based on the intended application and operating environment. |
Available Options
White disposable nonwoven or reusable polyesterSleeveless bib or long-sleeve apronAdjustable neck loop or snap-adjusted neck strapRear ties or low-profile buckle systemConductive-grid polyester optionIndividual or bulk clean packaging
Planning a Cleanroom Apron specification?
Send us your dimensions, installation conditions, performance targets and required surface finish.
