English
الألمانية
العربيةالحالي
الفرنسية
الإندونيسية
اليابانية
الكورية
اللغة الملاوية
البرتغالية
الروسية
الإسبانية
التايلاندية
اللغة التركية
اللغة الفيتنامية
اكسسوارات تركيب الغرف النظيفة
ختم اختراق الكابل
A multi-hole EPDM compression transit that organizes and seals several cables through one cleanroom wall opening.
- Six Cable Passages
- EPDM Compression Insert
- Stainless Face Plates
- Four-Point Clamping
مقدمة المنتج
The cable penetration seal combines a molded six-hole EPDM insert with two circular stainless pressure plates and four perimeter fasteners. Tightening the plates compresses the elastomer around individual cable routes and against the surrounding opening. A solid center and defined passages keep multiple services organized while presenting smooth, accessible faces on the partition.
الخصائص الرئيسية
Four-point plate compression loads the EPDM insert evenly.
A solid center preserves sealing material between adjacent openings.
Stainless pressure plates protect the elastomer edges and provide clean exposed surfaces.
مخاوف المنتج للعملاء
Multiple loose cables through one opening create irregular gaps, abrasion points and an untidy surface that is difficult to seal consistently.
Bundled cables leave uncontrolled air paths between conductors.Individual molded passages establish separate compression zones around each cable.
Sharp panel edges abrade cable jackets.The framed elastomer insert isolates cables from the cut opening.
Uneven tightening distorts the seal and leaves local gaps.Four evenly positioned fasteners distribute plate pressure across the insert.
Future cable changes are difficult with permanent potting compounds.The bolted assembly can be released for compatible cable replacement or insert servicing.
تطبيقات نموذجية
Cleanroom instrumentation cablesControl wiring penetrationsSensor lead routingUtility-panel cable transitsEquipment service openings
المعلمات الفنية
Typical construction ranges for a circular multi-cable cleanroom compression seal are listed below.
| المواد الأساسية | Molded black EPDM multi-hole insert with 304 or 316 stainless plates and fasteners |
|---|---|
| سمك اللوحة | 40-200 mm compatible wall or service-panel thickness |
| العرض الفعال | 5-40 mm cable diameter per molded passage |
| الحد الأقصى الطول | Up to 300 mm overall circular seal diameter |
| الصلب يواجه سمك | 2.00-5.00 mm stainless pressure-plate thickness |
| الكثافة الأساسية | Approximately 1100-1300 kg/m³ for EPDM |
| الموصلية الحرارية | Approximately 0.20-0.30 W/(m·K) for EPDM |
| إنهاء السطح | Black molded elastomer with brushed or satin stainless face plates |
| نوع المشترك | Bolted axial compression of a multi-hole cable-sealing insert |
| التخصيص | متوفر على أساس التطبيق المقصود وبيئة التشغيل. |
الخيارات المتاحة
Different hole countsMixed cable diametersEPDM or silicone insert304 or 316 stainless plates
Planning a Cable Penetration Seal specification?
أرسل لنا الأبعاد الخاصة بك، شروط التثبيت، أهداف الأداء والتشطيب السطحي المطلوب.
