Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Sistemas de parede e teto para sala limpa
Perfil de conexão do painel de sala limpa tipo H
An extruded aluminum H-section that receives two opposing cleanroom panels and maintains a straight, protected joint along a modular wall or ceiling run.
- Opposed channels for two panel edges
- Straight in-plane modular connection
- Compatible with multiple panel thicknesses
- Sealable exposed joint boundaries
Introdução do produto
The H-Type Cleanroom Panel Connecting Profile joins two sandwich panels edge to edge in the same plane. Its opposed channels locate both panel ends, cover exposed core edges and establish a repeatable joint width. The aluminum section can be used in straight wall runs, ceiling infill and removable service bays where a defined mechanical connection is preferred over a tongue-and-groove-only joint.
Características-chave
The H-section conceals both cut edges and limits direct exposure of the panel core.
A continuous visible face creates a deliberate architectural joint.
Multiple channel sizes accommodate common cleanroom panel thicknesses.
Straight perimeter lands support controlled sealant application on both sides.
Preocupações do produto do cliente
An in-line panel joint must keep two large panels aligned while protecting their edges and maintaining a sealable interface.
Independent panel ends can step out of plane and create a visible ridge.Opposed channels hold both edges against one shared extruded connector.
Cut sandwich-panel cores remain exposed at butt joints.The H-shaped profile encloses both ends within dedicated receiving channels.
A freehand butt joint varies in width over the height of a wall.The fixed extrusion geometry maintains a consistent center joint from end to end.
Replacing one service panel can disturb the neighboring wall module.A defined connector profile separates the panel interfaces and supports modular removal strategies.
Aplicações típicas
Straight modular cleanroom wall runsCeiling panel connectionsReplaceable service-bay infill panelsControlled-environment partition extensionsConnections between compatible panel modules
Parâmetros técnicos
Channel dimensions are selected to suit the connected sandwich-panel thickness. Thermal values for an insulated panel do not describe this solid aluminum joining component.
| Material principal | 6063-T5 extruded aluminum H-section |
|---|---|
| Painel de espessura | 50, 75, 80, 100 or 150 mm compatible variants |
| Largura efetiva | 50 mm typical visible joint face |
| Comprimento máximo | 6000 mm |
| Aço enfrentando espessura | N/A — the connector is an aluminum extrusion |
| Densidade Core | N/A — no insulated core; aluminum alloy density is approximately 2700 kg/m³ |
| Condutividade térmica | N/A — no insulated core; aluminum alloy is approximately 200 W/(m·K) |
| Superfície acabado | Electrostatic powder-coated or clear anodized aluminum |
| Tipo conjunto | Twin opposed H-channels with sealant-ready panel interfaces |
| Customização | Disponível com base na aplicação pretendida e ambiente operacional |
Opções disponíveis
H-profile for 50 mm panelsH-profile for 75 or 80 mm panelsH-profile for 100 or 150 mm panelsAnodized or powder-coated exposed finish
Planning a H-Type Cleanroom Panel Connecting Profile specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
