Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Sistemas de pared y techo de sala limpia
Perfil de conexión del panel de sala limpia tipo H
An extruded aluminum H-section that receives two opposing cleanroom panels and maintains a straight, protected joint along a modular wall or ceiling run.
- Opposed channels for two panel edges
- Straight in-plane modular connection
- Compatible with multiple panel thicknesses
- Sealable exposed joint boundaries
Introducción del producto
The H-Type Cleanroom Panel Connecting Profile joins two sandwich panels edge to edge in the same plane. Its opposed channels locate both panel ends, cover exposed core edges and establish a repeatable joint width. The aluminum section can be used in straight wall runs, ceiling infill and removable service bays where a defined mechanical connection is preferred over a tongue-and-groove-only joint.
Características clave
The H-section conceals both cut edges and limits direct exposure of the panel core.
A continuous visible face creates a deliberate architectural joint.
Multiple channel sizes accommodate common cleanroom panel thicknesses.
Straight perimeter lands support controlled sealant application on both sides.
Preocupaciones del producto del cliente
An in-line panel joint must keep two large panels aligned while protecting their edges and maintaining a sealable interface.
Independent panel ends can step out of plane and create a visible ridge.Opposed channels hold both edges against one shared extruded connector.
Cut sandwich-panel cores remain exposed at butt joints.The H-shaped profile encloses both ends within dedicated receiving channels.
A freehand butt joint varies in width over the height of a wall.The fixed extrusion geometry maintains a consistent center joint from end to end.
Replacing one service panel can disturb the neighboring wall module.A defined connector profile separates the panel interfaces and supports modular removal strategies.
Aplicaciones típicas
Straight modular cleanroom wall runsCeiling panel connectionsReplaceable service-bay infill panelsControlled-environment partition extensionsConnections between compatible panel modules
Parámetros técnicos
Channel dimensions are selected to suit the connected sandwich-panel thickness. Thermal values for an insulated panel do not describe this solid aluminum joining component.
| Materiales Core | 6063-T5 extruded aluminum H-section |
|---|---|
| Panel de espesor | 50, 75, 80, 100 or 150 mm compatible variants |
| Ancho efectivo | 50 mm typical visible joint face |
| Longitud máxima | 6000 mm |
| Acero frente a espesor | N/A — the connector is an aluminum extrusion |
| Densidad Core | N/A — no insulated core; aluminum alloy density is approximately 2700 kg/m³ |
| Conductividad térmica | N/A — no insulated core; aluminum alloy is approximately 200 W/(m·K) |
| Superficie acabada | Electrostatic powder-coated or clear anodized aluminum |
| Tipo conjunto | Twin opposed H-channels with sealant-ready panel interfaces |
| Customization | Disponible según la aplicación prevista y el entorno operativo |
Opciones disponibles
H-profile for 50 mm panelsH-profile for 75 or 80 mm panelsH-profile for 100 or 150 mm panelsAnodized or powder-coated exposed finish
Planning a H-Type Cleanroom Panel Connecting Profile specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
