클린룸 벽 및 천장 시스템

H 형 클린룸 패널 연결 프로파일

An extruded aluminum H-section that receives two opposing cleanroom panels and maintains a straight, protected joint along a modular wall or ceiling run.

Opposed channels for two panel edges
Straight in-plane modular connection
Compatible with multiple panel thicknesses
Sealable exposed joint boundaries

견적 요청 제품 찾아보기

상품 소개

The H-Type Cleanroom Panel Connecting Profile joins two sandwich panels edge to edge in the same plane. Its opposed channels locate both panel ends, cover exposed core edges and establish a repeatable joint width. The aluminum section can be used in straight wall runs, ceiling infill and removable service bays where a defined mechanical connection is preferred over a tongue-and-groove-only joint.

주요 기능

Twin opposed channels align neighboring panels along a common centerline.

The H-section conceals both cut edges and limits direct exposure of the panel core.

A continuous visible face creates a deliberate architectural joint.

Multiple channel sizes accommodate common cleanroom panel thicknesses.

Straight perimeter lands support controlled sealant application on both sides.

고객 제품 관심사

An in-line panel joint must keep two large panels aligned while protecting their edges and maintaining a sealable interface.

Independent panel ends can step out of plane and create a visible ridge.Opposed channels hold both edges against one shared extruded connector.

Cut sandwich-panel cores remain exposed at butt joints.The H-shaped profile encloses both ends within dedicated receiving channels.

A freehand butt joint varies in width over the height of a wall.The fixed extrusion geometry maintains a consistent center joint from end to end.

Replacing one service panel can disturb the neighboring wall module.A defined connector profile separates the panel interfaces and supports modular removal strategies.

일반적인 응용 프로그램

Straight modular cleanroom wall runsCeiling panel connectionsReplaceable service-bay infill panelsControlled-environment partition extensionsConnections between compatible panel modules

기술 매개변수

Channel dimensions are selected to suit the connected sandwich-panel thickness. Thermal values for an insulated panel do not describe this solid aluminum joining component.

핵심 재료	6063-T5 extruded aluminum H-section
패널 두께	50, 75, 80, 100 or 150 mm compatible variants
유효 폭	50 mm typical visible joint face
최대 길이	6000 mm
강철 면면 두께	N/A — the connector is an aluminum extrusion
코어 밀도	N / A - 단열 코어 없음; 알루미늄 합금 밀도는 약 2700 kg / m 3 입니다.
열전도도 (Thermal Conductivity)	N / A - 단열 코어 없음; 알루미늄 합금 약 200 W / (m · K)
표면 마무리	Electrostatic powder-coated or clear anodized aluminum
접합 유형	Twin opposed H-channels with sealant-ready panel interfaces
사용자 정의	사용 대상 어플리케이션 및 운영 환경에 따라 사용 가능

사용 가능한 옵션

H-profile for 50 mm panelsH-profile for 75 or 80 mm panelsH-profile for 100 or 150 mm panelsAnodized or powder-coated exposed finish

Planning a H-Type Cleanroom Panel Connecting Profile specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.