English
Немецкий
Арабский язык
Французский
Индонезийский
Японский язык
Корейский
Японский
Португальский
Русский языкТекущий
Испанский язык
Тайский
Турецкий
Вьетнамский язык
Стенные и потолочные системы для чистых комнат
Профиль соединения панели чистой комнаты типа H
An extruded aluminum H-section that receives two opposing cleanroom panels and maintains a straight, protected joint along a modular wall or ceiling run.
- Opposed channels for two panel edges
- Straight in-plane modular connection
- Compatible with multiple panel thicknesses
- Sealable exposed joint boundaries
Введение продукции
The H-Type Cleanroom Panel Connecting Profile joins two sandwich panels edge to edge in the same plane. Its opposed channels locate both panel ends, cover exposed core edges and establish a repeatable joint width. The aluminum section can be used in straight wall runs, ceiling infill and removable service bays where a defined mechanical connection is preferred over a tongue-and-groove-only joint.
Основные характеристики
The H-section conceals both cut edges and limits direct exposure of the panel core.
A continuous visible face creates a deliberate architectural joint.
Multiple channel sizes accommodate common cleanroom panel thicknesses.
Straight perimeter lands support controlled sealant application on both sides.
Обеспокоенность клиентов продуктами
An in-line panel joint must keep two large panels aligned while protecting their edges and maintaining a sealable interface.
Independent panel ends can step out of plane and create a visible ridge.Opposed channels hold both edges against one shared extruded connector.
Cut sandwich-panel cores remain exposed at butt joints.The H-shaped profile encloses both ends within dedicated receiving channels.
A freehand butt joint varies in width over the height of a wall.The fixed extrusion geometry maintains a consistent center joint from end to end.
Replacing one service panel can disturb the neighboring wall module.A defined connector profile separates the panel interfaces and supports modular removal strategies.
Типичные приложения
Straight modular cleanroom wall runsCeiling panel connectionsReplaceable service-bay infill panelsControlled-environment partition extensionsConnections between compatible panel modules
Технические параметры
Channel dimensions are selected to suit the connected sandwich-panel thickness. Thermal values for an insulated panel do not describe this solid aluminum joining component.
| Основной материал | 6063-T5 extruded aluminum H-section |
|---|---|
| Толщина панели | 50, 75, 80, 100 or 150 mm compatible variants |
| эффективная ширина | 50 mm typical visible joint face |
| Максимальная длина | 6000 mm |
| Толщина линий стали | N/A — the connector is an aluminum extrusion |
| Плотность ядра | N/A — no insulated core; aluminum alloy density is approximately 2700 kg/m³ |
| Теплопроводимость | N/A — no insulated core; aluminum alloy is approximately 200 W/(m·K) |
| Поверхностная отделка | Electrostatic powder-coated or clear anodized aluminum |
| Объединенный тип | Twin opposed H-channels with sealant-ready panel interfaces |
| Customization | Доступно в зависимости от предполагаемого приложения и операционной среды |
Доступные варианты
H-profile for 50 mm panelsH-profile for 75 or 80 mm panelsH-profile for 100 or 150 mm panelsAnodized or powder-coated exposed finish
Planning a H-Type Cleanroom Panel Connecting Profile specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
