Bahasa Inggris
Bahasa Jerman
Bahasa Arab
Bahasa Perancis: Bahasa Perancis
Bahasa IndonesiaSaat ini
Bahasa Jepang
Bahasa Korea
Bahasa Melayu
Bahasa Portugis
Bahasa Rusia
Bahasa Spanyol
Bahasa Thailand
Bahasa Turki
Bahasa Vietnam
Sistem Dinding dan Langit-langit Cleanroom
Panel Cleanroom H-Type Menghubungkan Profil
An extruded aluminum H-section that receives two opposing cleanroom panels and maintains a straight, protected joint along a modular wall or ceiling run.
- Opposed channels for two panel edges
- Straight in-plane modular connection
- Compatible with multiple panel thicknesses
- Sealable exposed joint boundaries
Perkenalan produk
The H-Type Cleanroom Panel Connecting Profile joins two sandwich panels edge to edge in the same plane. Its opposed channels locate both panel ends, cover exposed core edges and establish a repeatable joint width. The aluminum section can be used in straight wall runs, ceiling infill and removable service bays where a defined mechanical connection is preferred over a tongue-and-groove-only joint.
Fitur utama:
The H-section conceals both cut edges and limits direct exposure of the panel core.
A continuous visible face creates a deliberate architectural joint.
Multiple channel sizes accommodate common cleanroom panel thicknesses.
Straight perimeter lands support controlled sealant application on both sides.
Kekhawatiran produk pelanggan
An in-line panel joint must keep two large panels aligned while protecting their edges and maintaining a sealable interface.
Independent panel ends can step out of plane and create a visible ridge.Opposed channels hold both edges against one shared extruded connector.
Cut sandwich-panel cores remain exposed at butt joints.The H-shaped profile encloses both ends within dedicated receiving channels.
A freehand butt joint varies in width over the height of a wall.The fixed extrusion geometry maintains a consistent center joint from end to end.
Replacing one service panel can disturb the neighboring wall module.A defined connector profile separates the panel interfaces and supports modular removal strategies.
Aplikasi yang Tipis
Straight modular cleanroom wall runsCeiling panel connectionsReplaceable service-bay infill panelsControlled-environment partition extensionsConnections between compatible panel modules
Parameter teknis
Channel dimensions are selected to suit the connected sandwich-panel thickness. Thermal values for an insulated panel do not describe this solid aluminum joining component.
| Bahan inti | 6063-T5 extruded aluminum H-section |
|---|---|
| Ketebalan Panel (Panel Thickness) | 50, 75, 80, 100 or 150 mm compatible variants |
| Efektif lebar | 50 mm typical visible joint face |
| Panjang maksimum | 6000 mm ZXQ000003 |
| Baja menghadap ketebalan | N/A — the connector is an aluminum extrusion |
| Kepadatan inti (core density) | N/A — no insulated core; aluminum alloy density is approximately 2700 kg/m³ |
| Konduktivitas Termal (Thermal Conductivity) | N/A — no insulated core; aluminum alloy is approximately 200 W/(m·K) |
| Permukaan selesai | Electrostatic powder-coated or clear anodized aluminum |
| Jenis Bersama | Twin opposed H-channels with sealant-ready panel interfaces |
| Customization (Kustomisasi) | A Tersedia berdasarkan aplikasi dan lingkungan operasi yang dimaksudkan |
Pilihan yang tersedia
H-profile for 50 mm panelsH-profile for 75 or 80 mm panelsH-profile for 100 or 150 mm panelsAnodized or powder-coated exposed finish
Planning a H-Type Cleanroom Panel Connecting Profile specification?
Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.
