Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Cleanroom mur et systèmes de plafond
Profil de connexion du panneau de salle blanche H-Type
An extruded aluminum H-section that receives two opposing cleanroom panels and maintains a straight, protected joint along a modular wall or ceiling run.
- Opposed channels for two panel edges
- Straight in-plane modular connection
- Compatible with multiple panel thicknesses
- Sealable exposed joint boundaries
Introduction de produit
The H-Type Cleanroom Panel Connecting Profile joins two sandwich panels edge to edge in the same plane. Its opposed channels locate both panel ends, cover exposed core edges and establish a repeatable joint width. The aluminum section can be used in straight wall runs, ceiling infill and removable service bays where a defined mechanical connection is preferred over a tongue-and-groove-only joint.
Key Features
The H-section conceals both cut edges and limits direct exposure of the panel core.
A continuous visible face creates a deliberate architectural joint.
Multiple channel sizes accommodate common cleanroom panel thicknesses.
Straight perimeter lands support controlled sealant application on both sides.
Préoccupations du client produit
An in-line panel joint must keep two large panels aligned while protecting their edges and maintaining a sealable interface.
Independent panel ends can step out of plane and create a visible ridge.Opposed channels hold both edges against one shared extruded connector.
Cut sandwich-panel cores remain exposed at butt joints.The H-shaped profile encloses both ends within dedicated receiving channels.
A freehand butt joint varies in width over the height of a wall.The fixed extrusion geometry maintains a consistent center joint from end to end.
Replacing one service panel can disturb the neighboring wall module.A defined connector profile separates the panel interfaces and supports modular removal strategies.
Les applications typiques
Straight modular cleanroom wall runsCeiling panel connectionsReplaceable service-bay infill panelsControlled-environment partition extensionsConnections between compatible panel modules
Paramètres techniques
Channel dimensions are selected to suit the connected sandwich-panel thickness. Thermal values for an insulated panel do not describe this solid aluminum joining component.
| Matériaux de base | 6063-T5 extruded aluminum H-section |
|---|---|
| Panneau épaisseur | 50, 75, 80, 100 or 150 mm compatible variants |
| Largeur effective | 50 mm typical visible joint face |
| Longueur maximale | 6000 mm |
| Acier face épaisseur | N/A — the connector is an aluminum extrusion |
| Densité Core | N / A - pas de noyau isolé ; densité d'alliage d'aluminium d'environ 2700 kg / m3 |
| Conductivité thermique | N / A - aucun noyau isolé ; alliage d'aluminium est d'environ 200 W / (m · K) |
| surface finie | Electrostatic powder-coated or clear anodized aluminum |
| Type joint | Twin opposed H-channels with sealant-ready panel interfaces |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation |
Options disponibles
H-profile for 50 mm panelsH-profile for 75 or 80 mm panelsH-profile for 100 or 150 mm panelsAnodized or powder-coated exposed finish
Planning a H-Type Cleanroom Panel Connecting Profile specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
