Three-quarter view of a galvanized cleanroom panel connector between insulated panel edges

Acessórios de instalação de sala limpa

Z Conector de painel de sala limpa

A concealed galvanized connector that aligns adjacent insulated cleanroom panel edges and transfers joint loads into their internal channels.

Concealed Joint Hardware
Positive Edge Alignment
Galvanized Steel Strength
Serviceable Mechanical Fixing

Solicite um orçamento. Browse produtos

Introdução do produto

The cleanroom panel connector is a formed galvanized-steel component placed between compatible sandwich-panel edge channels. Its tongues, flanges or locating ribs engage both panel edges so the finished faces remain aligned while screws secure the connector to the internal reinforcement. Because the hardware is concealed by the closed joint, the exposed cleanroom surface can remain flush and ready for final sealing.

Características-chave

Formed locating features register both panel edges before final tightening.

Galvanized steel provides practical stiffness and corrosion protection inside the concealed joint.

Countersunk or recessed fixing points keep fastener heads below the finished panel face.

Connector geometry can be matched to wall, ceiling or return-panel internal channels.

Preocupações do produto do cliente

Adjacent panels must stay flush during installation even when their light-gauge facings cannot carry alignment loads alone.

Panel faces step out of alignment while installers tighten the joint.Locating tongues engage both internal channels and establish a common joint plane.

Surface fasteners create visible recesses that are difficult to finish hygienically.The connector and its fixings remain concealed within the panel-edge cavity.

Thin sheet facings deform when joint loads are concentrated at one screw.A formed connector spreads load along the internal edge reinforcement.

Generic brackets do not fit the panel manufacturer's tongue-and-groove geometry.Connector width, rib position and hole pattern are matched to the selected panel section.

Aplicações típicas

Cleanroom wall-panel jointsWalkable ceiling panel connectionsPartition return panelsDoor-frame infill interfacesModular enclosure assembly

Parâmetros técnicos

Typical construction ranges for a formed galvanized cleanroom sandwich-panel connector are shown below.

Material principal	Formed galvanized carbon-steel connector with stamped ribs and fixing holes
Painel de espessura	50-150 mm compatible sandwich-panel thickness
Largura efetiva	40-200 mm connector engagement width
Comprimento máximo	Up to 3000 mm continuous spline or 500 mm discrete connector length
Aço enfrentando espessura	1.00-2.50 mm galvanized connector sheet thickness
Densidade Core	Approximately 7850 kg/m³ for galvanized carbon steel
Condutividade térmica	Approximately 45-60 W/(m·K) for carbon-steel connector parts
Superfície acabado	Silver zinc-coated formed steel concealed within white coated panel edges
Tipo conjunto	Concealed spline, tongue, bridging plate or channel engagement with mechanical fixing
Customização	Disponível com base na aplicação pretendida e no ambiente operacional.

Opções disponíveis

Continuous spline or discrete plateWall or ceiling profilePre-punched fixing holesStainless-steel construction

Planning a Cleanroom Panel Connector specification?

Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.

Fale com a nossa equipe