Three-quarter view of a galvanized cleanroom panel connector between insulated panel edges

클린룸 설치 액세서리

클린룸 패널 커넥터

A concealed galvanized connector that aligns adjacent insulated cleanroom panel edges and transfers joint loads into their internal channels.

Concealed Joint Hardware
Positive Edge Alignment
Galvanized Steel Strength
Serviceable Mechanical Fixing

견적 요청 제품 찾아보기

상품 소개

The cleanroom panel connector is a formed galvanized-steel component placed between compatible sandwich-panel edge channels. Its tongues, flanges or locating ribs engage both panel edges so the finished faces remain aligned while screws secure the connector to the internal reinforcement. Because the hardware is concealed by the closed joint, the exposed cleanroom surface can remain flush and ready for final sealing.

주요 기능

Formed locating features register both panel edges before final tightening.

Galvanized steel provides practical stiffness and corrosion protection inside the concealed joint.

Countersunk or recessed fixing points keep fastener heads below the finished panel face.

Connector geometry can be matched to wall, ceiling or return-panel internal channels.

고객 제품 관심사

Adjacent panels must stay flush during installation even when their light-gauge facings cannot carry alignment loads alone.

Panel faces step out of alignment while installers tighten the joint.Locating tongues engage both internal channels and establish a common joint plane.

Surface fasteners create visible recesses that are difficult to finish hygienically.The connector and its fixings remain concealed within the panel-edge cavity.

Thin sheet facings deform when joint loads are concentrated at one screw.A formed connector spreads load along the internal edge reinforcement.

Generic brackets do not fit the panel manufacturer's tongue-and-groove geometry.Connector width, rib position and hole pattern are matched to the selected panel section.

일반적인 응용 프로그램

Cleanroom wall-panel jointsWalkable ceiling panel connectionsPartition return panelsDoor-frame infill interfacesModular enclosure assembly

기술 매개변수

Typical construction ranges for a formed galvanized cleanroom sandwich-panel connector are shown below.

핵심 재료	Formed galvanized carbon-steel connector with stamped ribs and fixing holes
패널 두께	50-150 mm compatible sandwich-panel thickness
유효 폭	40-200 mm connector engagement width
최대 길이	Up to 3000 mm continuous spline or 500 mm discrete connector length
강철 면면 두께	1.00-2.50 mm galvanized connector sheet thickness
코어 밀도	Approximately 7850 kg/m³ for galvanized carbon steel
열전도도 (Thermal Conductivity)	Approximately 45-60 W/(m·K) for carbon-steel connector parts
표면 마무리	Silver zinc-coated formed steel concealed within white coated panel edges
접합 유형	Concealed spline, tongue, bridging plate or channel engagement with mechanical fixing
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Continuous spline or discrete plateWall or ceiling profilePre-punched fixing holesStainless-steel construction

Planning a Cleanroom Panel Connector specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.