English
Немецкий
Арабский язык
Французский
Индонезийский
Японский язык
Корейский
Японский
Португальский
Русский языкТекущий
Испанский язык
Тайский
Турецкий
Вьетнамский язык
Аксессуары для установки в чистых помещениях
Соединитель панели для чистых помещений
A concealed galvanized connector that aligns adjacent insulated cleanroom panel edges and transfers joint loads into their internal channels.
- Concealed Joint Hardware
- Positive Edge Alignment
- Galvanized Steel Strength
- Serviceable Mechanical Fixing
Введение продукции
The cleanroom panel connector is a formed galvanized-steel component placed between compatible sandwich-panel edge channels. Its tongues, flanges or locating ribs engage both panel edges so the finished faces remain aligned while screws secure the connector to the internal reinforcement. Because the hardware is concealed by the closed joint, the exposed cleanroom surface can remain flush and ready for final sealing.
Основные характеристики
Galvanized steel provides practical stiffness and corrosion protection inside the concealed joint.
Countersunk or recessed fixing points keep fastener heads below the finished panel face.
Connector geometry can be matched to wall, ceiling or return-panel internal channels.
Обеспокоенность клиентов продуктами
Adjacent panels must stay flush during installation even when their light-gauge facings cannot carry alignment loads alone.
Panel faces step out of alignment while installers tighten the joint.Locating tongues engage both internal channels and establish a common joint plane.
Surface fasteners create visible recesses that are difficult to finish hygienically.The connector and its fixings remain concealed within the panel-edge cavity.
Thin sheet facings deform when joint loads are concentrated at one screw.A formed connector spreads load along the internal edge reinforcement.
Generic brackets do not fit the panel manufacturer's tongue-and-groove geometry.Connector width, rib position and hole pattern are matched to the selected panel section.
Типичные приложения
Cleanroom wall-panel jointsWalkable ceiling panel connectionsPartition return panelsDoor-frame infill interfacesModular enclosure assembly
Технические параметры
Typical construction ranges for a formed galvanized cleanroom sandwich-panel connector are shown below.
| Основной материал | Formed galvanized carbon-steel connector with stamped ribs and fixing holes |
|---|---|
| Толщина панели | 50-150 mm compatible sandwich-panel thickness |
| эффективная ширина | 40-200 mm connector engagement width |
| Максимальная длина | Up to 3000 mm continuous spline or 500 mm discrete connector length |
| Толщина линий стали | 1.00-2.50 mm galvanized connector sheet thickness |
| Плотность ядра | Approximately 7850 kg/m³ for galvanized carbon steel |
| Теплопроводимость | Approximately 45-60 W/(m·K) for carbon-steel connector parts |
| Поверхностная отделка | Silver zinc-coated formed steel concealed within white coated panel edges |
| Объединенный тип | Concealed spline, tongue, bridging plate or channel engagement with mechanical fixing |
| Customization | Доступно в зависимости от предполагаемого применения и операционной среды. |
Доступные варианты
Continuous spline or discrete plateWall or ceiling profilePre-punched fixing holesStainless-steel construction
Planning a Cleanroom Panel Connector specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
