Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Accesorios de instalación de sala limpia
Conector de panel de sala limpia
A concealed galvanized connector that aligns adjacent insulated cleanroom panel edges and transfers joint loads into their internal channels.
- Concealed Joint Hardware
- Positive Edge Alignment
- Galvanized Steel Strength
- Serviceable Mechanical Fixing
Introducción del producto
The cleanroom panel connector is a formed galvanized-steel component placed between compatible sandwich-panel edge channels. Its tongues, flanges or locating ribs engage both panel edges so the finished faces remain aligned while screws secure the connector to the internal reinforcement. Because the hardware is concealed by the closed joint, the exposed cleanroom surface can remain flush and ready for final sealing.
Características clave
Galvanized steel provides practical stiffness and corrosion protection inside the concealed joint.
Countersunk or recessed fixing points keep fastener heads below the finished panel face.
Connector geometry can be matched to wall, ceiling or return-panel internal channels.
Preocupaciones del producto del cliente
Adjacent panels must stay flush during installation even when their light-gauge facings cannot carry alignment loads alone.
Panel faces step out of alignment while installers tighten the joint.Locating tongues engage both internal channels and establish a common joint plane.
Surface fasteners create visible recesses that are difficult to finish hygienically.The connector and its fixings remain concealed within the panel-edge cavity.
Thin sheet facings deform when joint loads are concentrated at one screw.A formed connector spreads load along the internal edge reinforcement.
Generic brackets do not fit the panel manufacturer's tongue-and-groove geometry.Connector width, rib position and hole pattern are matched to the selected panel section.
Aplicaciones típicas
Cleanroom wall-panel jointsWalkable ceiling panel connectionsPartition return panelsDoor-frame infill interfacesModular enclosure assembly
Parámetros técnicos
Typical construction ranges for a formed galvanized cleanroom sandwich-panel connector are shown below.
| Materiales Core | Formed galvanized carbon-steel connector with stamped ribs and fixing holes |
|---|---|
| Panel de espesor | 50-150 mm compatible sandwich-panel thickness |
| Ancho efectivo | 40-200 mm connector engagement width |
| Longitud máxima | Up to 3000 mm continuous spline or 500 mm discrete connector length |
| Acero frente a espesor | 1.00-2.50 mm galvanized connector sheet thickness |
| Densidad Core | Approximately 7850 kg/m³ for galvanized carbon steel |
| Conductividad térmica | Approximately 45-60 W/(m·K) for carbon-steel connector parts |
| Superficie acabada | Silver zinc-coated formed steel concealed within white coated panel edges |
| Tipo conjunto | Concealed spline, tongue, bridging plate or channel engagement with mechanical fixing |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Opciones disponibles
Continuous spline or discrete plateWall or ceiling profilePre-punched fixing holesStainless-steel construction
Planning a Cleanroom Panel Connector specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
