Englisch
DeutschCurrent
Arabisch
Französisch
indonesisch
Japanisch
Koreanisch
Malaiisch
Portugiesisch
Russisch
Spanisch
Thailändisch
Türkischer Sprache
Vietnamesisch
Cleanroom Installation Zubehör
Cleanroom Panel Connector
A concealed galvanized connector that aligns adjacent insulated cleanroom panel edges and transfers joint loads into their internal channels.
- Concealed Joint Hardware
- Positive Edge Alignment
- Galvanized Steel Strength
- Serviceable Mechanical Fixing
Produkteinführung
The cleanroom panel connector is a formed galvanized-steel component placed between compatible sandwich-panel edge channels. Its tongues, flanges or locating ribs engage both panel edges so the finished faces remain aligned while screws secure the connector to the internal reinforcement. Because the hardware is concealed by the closed joint, the exposed cleanroom surface can remain flush and ready for final sealing.
Key Features
Galvanized steel provides practical stiffness and corrosion protection inside the concealed joint.
Countersunk or recessed fixing points keep fastener heads below the finished panel face.
Connector geometry can be matched to wall, ceiling or return-panel internal channels.
Kunden Produktbedenken
Adjacent panels must stay flush during installation even when their light-gauge facings cannot carry alignment loads alone.
Panel faces step out of alignment while installers tighten the joint.Locating tongues engage both internal channels and establish a common joint plane.
Surface fasteners create visible recesses that are difficult to finish hygienically.The connector and its fixings remain concealed within the panel-edge cavity.
Thin sheet facings deform when joint loads are concentrated at one screw.A formed connector spreads load along the internal edge reinforcement.
Generic brackets do not fit the panel manufacturer's tongue-and-groove geometry.Connector width, rib position and hole pattern are matched to the selected panel section.
Typische Anwendungen
Cleanroom wall-panel jointsWalkable ceiling panel connectionsPartition return panelsDoor-frame infill interfacesModular enclosure assembly
Technische Parameter
Typical construction ranges for a formed galvanized cleanroom sandwich-panel connector are shown below.
| Core Material | Formed galvanized carbon-steel connector with stamped ribs and fixing holes |
|---|---|
| Panel Dicke | 50-150 mm compatible sandwich-panel thickness |
| Effektive Breite | 40-200 mm connector engagement width |
| Maximale Länge | Up to 3000 mm continuous spline or 500 mm discrete connector length |
| Stahl facing Dicke | 1.00-2.50 mm galvanized connector sheet thickness |
| Kerndichte | Approximately 7850 kg/m³ for galvanized carbon steel |
| Thermische Leitfähigkeit | Approximately 45-60 W/(m·K) for carbon-steel connector parts |
| Oberfläche Finish | Silver zinc-coated formed steel concealed within white coated panel edges |
| Gemeinsamer Typ | Concealed spline, tongue, bridging plate or channel engagement with mechanical fixing |
| Customisierung | Verfügbar je nach beabsichtigter Anwendung und Betriebsumgebung. |
Verfügbare Optionen
Continuous spline or discrete plateWall or ceiling profilePre-punched fixing holesStainless-steel construction
Planning a Cleanroom Panel Connector specification?
Senden Sie uns Ihre Abmessungen, Installationsbedingungen, Leistungsziele und gewünschte Oberflächenveredelung.
