Three-quarter view of a galvanized cleanroom panel connector between insulated panel edges

Temiz Oda Kurulum Aksesuarları

Temiz Oda Panel Konektörü

A concealed galvanized connector that aligns adjacent insulated cleanroom panel edges and transfers joint loads into their internal channels.

Concealed Joint Hardware
Positive Edge Alignment
Galvanized Steel Strength
Serviceable Mechanical Fixing

Alıntı isteği Browse ürünleri

Ürün tanıtımı

The cleanroom panel connector is a formed galvanized-steel component placed between compatible sandwich-panel edge channels. Its tongues, flanges or locating ribs engage both panel edges so the finished faces remain aligned while screws secure the connector to the internal reinforcement. Because the hardware is concealed by the closed joint, the exposed cleanroom surface can remain flush and ready for final sealing.

Ana Özellikler

Formed locating features register both panel edges before final tightening.

Galvanized steel provides practical stiffness and corrosion protection inside the concealed joint.

Countersunk or recessed fixing points keep fastener heads below the finished panel face.

Connector geometry can be matched to wall, ceiling or return-panel internal channels.

Müşteri Ürün Sorunları

Adjacent panels must stay flush during installation even when their light-gauge facings cannot carry alignment loads alone.

Panel faces step out of alignment while installers tighten the joint.Locating tongues engage both internal channels and establish a common joint plane.

Surface fasteners create visible recesses that are difficult to finish hygienically.The connector and its fixings remain concealed within the panel-edge cavity.

Thin sheet facings deform when joint loads are concentrated at one screw.A formed connector spreads load along the internal edge reinforcement.

Generic brackets do not fit the panel manufacturer's tongue-and-groove geometry.Connector width, rib position and hole pattern are matched to the selected panel section.

Tipik uygulamalar

Cleanroom wall-panel jointsWalkable ceiling panel connectionsPartition return panelsDoor-frame infill interfacesModular enclosure assembly

Teknik parametreler

Typical construction ranges for a formed galvanized cleanroom sandwich-panel connector are shown below.

Temel malzemeler	Formed galvanized carbon-steel connector with stamped ribs and fixing holes
Panel kalınlığı	50-150 mm compatible sandwich-panel thickness
Effective Width (Etkili Genişlik)	40-200 mm connector engagement width
Maksimum uzunluk	Up to 3000 mm continuous spline or 500 mm discrete connector length
Çelik yüz yüze kalınlığı	1.00-2.50 mm galvanized connector sheet thickness
Core Density (Çekirdek Yoğunluğu)	Approximately 7850 kg/m³ for galvanized carbon steel
Termal İletkenlik	Approximately 45-60 W/(m·K) for carbon-steel connector parts
Yüzey bitirme	Silver zinc-coated formed steel concealed within white coated panel edges
Ortak tip	Concealed spline, tongue, bridging plate or channel engagement with mechanical fixing
Customization (Özelleşme)	Kullanılan uygulama ve çalışma ortamına göre kullanılabilir.

Mevcut Seçenekler

Continuous spline or discrete plateWall or ceiling profilePre-punched fixing holesStainless-steel construction

Planning a Cleanroom Panel Connector specification?

Bize boyutlarınızı, montaj koşullarınızı, performans hedeflerinizi ve gerekli yüzey kaplamalarınızı gönderin.

Ekibimizle konuşun