Three-quarter view of a galvanized cleanroom panel connector between insulated panel edges

Aksesoris Instalasi Cleanroom

Konektor Panel Cleanroom

A concealed galvanized connector that aligns adjacent insulated cleanroom panel edges and transfers joint loads into their internal channels.

Concealed Joint Hardware
Positive Edge Alignment
Galvanized Steel Strength
Serviceable Mechanical Fixing

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The cleanroom panel connector is a formed galvanized-steel component placed between compatible sandwich-panel edge channels. Its tongues, flanges or locating ribs engage both panel edges so the finished faces remain aligned while screws secure the connector to the internal reinforcement. Because the hardware is concealed by the closed joint, the exposed cleanroom surface can remain flush and ready for final sealing.

Fitur utama:

Formed locating features register both panel edges before final tightening.

Galvanized steel provides practical stiffness and corrosion protection inside the concealed joint.

Countersunk or recessed fixing points keep fastener heads below the finished panel face.

Connector geometry can be matched to wall, ceiling or return-panel internal channels.

Kekhawatiran produk pelanggan

Adjacent panels must stay flush during installation even when their light-gauge facings cannot carry alignment loads alone.

Panel faces step out of alignment while installers tighten the joint.Locating tongues engage both internal channels and establish a common joint plane.

Surface fasteners create visible recesses that are difficult to finish hygienically.The connector and its fixings remain concealed within the panel-edge cavity.

Thin sheet facings deform when joint loads are concentrated at one screw.A formed connector spreads load along the internal edge reinforcement.

Generic brackets do not fit the panel manufacturer's tongue-and-groove geometry.Connector width, rib position and hole pattern are matched to the selected panel section.

Aplikasi yang Tipis

Cleanroom wall-panel jointsWalkable ceiling panel connectionsPartition return panelsDoor-frame infill interfacesModular enclosure assembly

Parameter teknis

Typical construction ranges for a formed galvanized cleanroom sandwich-panel connector are shown below.

Bahan inti	Formed galvanized carbon-steel connector with stamped ribs and fixing holes
Ketebalan Panel (Panel Thickness)	50-150 mm compatible sandwich-panel thickness
Efektif lebar	40-200 mm connector engagement width
Panjang maksimum	Up to 3000 mm continuous spline or 500 mm discrete connector length
Baja menghadap ketebalan	1.00-2.50 mm galvanized connector sheet thickness
Kepadatan inti (core density)	Approximately 7850 kg/m³ for galvanized carbon steel
Konduktivitas Termal (Thermal Conductivity)	Approximately 45-60 W/(m·K) for carbon-steel connector parts
Permukaan selesai	Silver zinc-coated formed steel concealed within white coated panel edges
Jenis Bersama	Concealed spline, tongue, bridging plate or channel engagement with mechanical fixing
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

Continuous spline or discrete plateWall or ceiling profilePre-punched fixing holesStainless-steel construction

Planning a Cleanroom Panel Connector specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami