Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Iluminação de sala limpa e equipamentos elétricos
Sistema de chamadas de sala limpa
A supervised call-and-confirmation system that lets cleanroom personnel request assistance through large sealed wall buttons.
- Large Sealed Call Button
- Visible Call Confirmation
- Supervised Control Circuit
- Remote Acknowledge and Reset
Introdução do produto
The cleanroom call system connects flush wall call points to corridor indicators, an operator annunciator or a network server. A large colored membrane or stainless push button registers the request and illuminates to confirm it was received. Separate acknowledge and reset logic prevents a call from disappearing silently, while supervised wiring reports open-circuit or device faults.
Características-chave
A colored illuminated ring confirms that the system recorded the request.
Supervised wiring distinguishes a real call from a broken connection.
Remote annunciation identifies the originating room or call point.
Defined acknowledge and reset stages keep active requests visible until handled.
Preocupações do produto do cliente
A simple push button is insufficient when users need confirmation, room identification and assurance that a broken wire has not disabled the call path.
A small button is hard to locate and press through gloves.A large high-contrast sealed actuator provides an obvious tactile target.
The caller cannot tell whether the signal reached an operator.A local light and optional tone confirm registration immediately.
A cable fault looks the same as a quiet inactive system.Supervised inputs raise a distinct trouble condition for open or short circuits.
Calls are cleared before assistance actually arrives.Separate acknowledge and local reset steps preserve the request workflow.
Aplicações típicas
Cleanroom assistance requestsGowning room support callsLaboratory emergency pointsMaterial airlock pickup calls
Parâmetros técnicos
Typical configurable construction ranges for a cleanroom call system are listed below.
| Material principal | Stainless flush plates with sealed call/reset controls, LED indicators, supervised controller and low-voltage wiring |
|---|---|
| Painel de espessura | 1.5-3.0 mm cleanroom call-point plate thickness |
| Largura efetiva | 86-240 mm call-station face width |
| Comprimento máximo | Up to 320 mm overall station height |
| Aço enfrentando espessura | 1.5-3.0 mm SUS304/SUS316L front plate |
| Densidade Core | Approximately 7900-8000 kg/m³ for the stainless call-point plate |
| Condutividade térmica | 14-16 W/(m·K) for the stainless front plate |
| Superfície acabado | Fine-brushed stainless with red, blue, green or amber illuminated sealed buttons |
| Tipo conjunto | Flush gasketed wall plate with sealed actuators and supervised rear controller terminal connection |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Call, reset and emergency functionsSingle-room or networked annunciationAudible and visual confirmationPull-cord or wall-button input
Planning a Cleanroom Call System specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
