Cleanroom call system station with large red sealed button and confirmation light

クリーンルーム照明 · 電気機器

クリーンルームコールシステム

A supervised call-and-confirmation system that lets cleanroom personnel request assistance through large sealed wall buttons.

Large Sealed Call Button
Visible Call Confirmation
Supervised Control Circuit
Remote Acknowledge and Reset

見積もりリクエスト製品案内

商品紹介

The cleanroom call system connects flush wall call points to corridor indicators, an operator annunciator or a network server. A large colored membrane or stainless push button registers the request and illuminates to confirm it was received. Separate acknowledge and reset logic prevents a call from disappearing silently, while supervised wiring reports open-circuit or device faults.

主要な特徴

The broad call control can be operated through double gloves.

A colored illuminated ring confirms that the system recorded the request.

Supervised wiring distinguishes a real call from a broken connection.

Remote annunciation identifies the originating room or call point.

Defined acknowledge and reset stages keep active requests visible until handled.

お客様の製品に関する懸念事項

A simple push button is insufficient when users need confirmation, room identification and assurance that a broken wire has not disabled the call path.

A small button is hard to locate and press through gloves.A large high-contrast sealed actuator provides an obvious tactile target.

The caller cannot tell whether the signal reached an operator.A local light and optional tone confirm registration immediately.

A cable fault looks the same as a quiet inactive system.Supervised inputs raise a distinct trouble condition for open or short circuits.

Calls are cleared before assistance actually arrives.Separate acknowledge and local reset steps preserve the request workflow.

典型的な用途

Cleanroom assistance requestsGowning room support callsLaboratory emergency pointsMaterial airlock pickup calls

技術的なパラメータ

Typical configurable construction ranges for a cleanroom call system are listed below.

コア材料	Stainless flush plates with sealed call/reset controls, LED indicators, supervised controller and low-voltage wiring
パネルの厚さ	1.5-3.0 mm cleanroom call-point plate thickness
有効幅	86-240 mm call-station face width
最大長さ	Up to 320 mm overall station height
鋼鉄の厚さを直面する	1.5-3.0 mm SUS304/SUS316L front plate
コア密度	Approximately 7900-8000 kg/m³ for the stainless call-point plate
熱伝導率	14-16 W/(m·K) for the stainless front plate
表面仕上げ	Fine-brushed stainless with red, blue, green or amber illuminated sealed buttons
ジョイントタイプ	Flush gasketed wall plate with sealed actuators and supervised rear controller terminal connection
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Call, reset and emergency functionsSingle-room or networked annunciationAudible and visual confirmationPull-cord or wall-button input

Planning a Cleanroom Call System specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する