Cleanroom call system station with large red sealed button and confirmation light

Pencahayaan bilik bersih dan peralatan elektrik

Sistem Panggilan Bilik Bersih

A supervised call-and-confirmation system that lets cleanroom personnel request assistance through large sealed wall buttons.

Large Sealed Call Button
Visible Call Confirmation
Supervised Control Circuit
Remote Acknowledge and Reset

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The cleanroom call system connects flush wall call points to corridor indicators, an operator annunciator or a network server. A large colored membrane or stainless push button registers the request and illuminates to confirm it was received. Separate acknowledge and reset logic prevents a call from disappearing silently, while supervised wiring reports open-circuit or device faults.

Ciri-ciri Utama

The broad call control can be operated through double gloves.

A colored illuminated ring confirms that the system recorded the request.

Supervised wiring distinguishes a real call from a broken connection.

Remote annunciation identifies the originating room or call point.

Defined acknowledge and reset stages keep active requests visible until handled.

Kebimbangan Produk Pelanggan

A simple push button is insufficient when users need confirmation, room identification and assurance that a broken wire has not disabled the call path.

A small button is hard to locate and press through gloves.A large high-contrast sealed actuator provides an obvious tactile target.

The caller cannot tell whether the signal reached an operator.A local light and optional tone confirm registration immediately.

A cable fault looks the same as a quiet inactive system.Supervised inputs raise a distinct trouble condition for open or short circuits.

Calls are cleared before assistance actually arrives.Separate acknowledge and local reset steps preserve the request workflow.

Permohonan yang biasa

Cleanroom assistance requestsGowning room support callsLaboratory emergency pointsMaterial airlock pickup calls

Parameter teknikal

Typical configurable construction ranges for a cleanroom call system are listed below.

Bahan Teras	Stainless flush plates with sealed call/reset controls, LED indicators, supervised controller and low-voltage wiring
Ketebalan Panel	1.5-3.0 mm cleanroom call-point plate thickness
Lebar berkesan	86-240 mm call-station face width
Panjang maksimum	Up to 320 mm overall station height
Keluli Menghadapi Ketebalan	1.5-3.0 mm SUS304/SUS316L front plate
Ketumpatan teras	Approximately 7900-8000 kg/m³ for the stainless call-point plate
Kekonduksian Terma	14-16 W/(m·K) for the stainless front plate
Kemasan permukaan	Fine-brushed stainless with red, blue, green or amber illuminated sealed buttons
Jenis Bersatu	Flush gasketed wall plate with sealed actuators and supervised rear controller terminal connection
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

Call, reset and emergency functionsSingle-room or networked annunciationAudible and visual confirmationPull-cord or wall-button input

Planning a Cleanroom Call System specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami