English
Немецкий
Арабский язык
Французский
Индонезийский
Японский язык
Корейский
Японский
Португальский
Русский языкТекущий
Испанский язык
Тайский
Турецкий
Вьетнамский язык
Освещение и электрическое оборудование в чистых помещениях
Система вызова чистых комнат
A supervised call-and-confirmation system that lets cleanroom personnel request assistance through large sealed wall buttons.
- Large Sealed Call Button
- Visible Call Confirmation
- Supervised Control Circuit
- Remote Acknowledge and Reset
Введение продукции
The cleanroom call system connects flush wall call points to corridor indicators, an operator annunciator or a network server. A large colored membrane or stainless push button registers the request and illuminates to confirm it was received. Separate acknowledge and reset logic prevents a call from disappearing silently, while supervised wiring reports open-circuit or device faults.
Основные характеристики
A colored illuminated ring confirms that the system recorded the request.
Supervised wiring distinguishes a real call from a broken connection.
Remote annunciation identifies the originating room or call point.
Defined acknowledge and reset stages keep active requests visible until handled.
Обеспокоенность клиентов продуктами
A simple push button is insufficient when users need confirmation, room identification and assurance that a broken wire has not disabled the call path.
A small button is hard to locate and press through gloves.A large high-contrast sealed actuator provides an obvious tactile target.
The caller cannot tell whether the signal reached an operator.A local light and optional tone confirm registration immediately.
A cable fault looks the same as a quiet inactive system.Supervised inputs raise a distinct trouble condition for open or short circuits.
Calls are cleared before assistance actually arrives.Separate acknowledge and local reset steps preserve the request workflow.
Типичные приложения
Cleanroom assistance requestsGowning room support callsLaboratory emergency pointsMaterial airlock pickup calls
Технические параметры
Typical configurable construction ranges for a cleanroom call system are listed below.
| Основной материал | Stainless flush plates with sealed call/reset controls, LED indicators, supervised controller and low-voltage wiring |
|---|---|
| Толщина панели | 1.5-3.0 mm cleanroom call-point plate thickness |
| эффективная ширина | 86-240 mm call-station face width |
| Максимальная длина | Up to 320 mm overall station height |
| Толщина линий стали | 1.5-3.0 mm SUS304/SUS316L front plate |
| Плотность ядра | Approximately 7900-8000 kg/m³ for the stainless call-point plate |
| Теплопроводимость | 14-16 W/(m·K) for the stainless front plate |
| Поверхностная отделка | Fine-brushed stainless with red, blue, green or amber illuminated sealed buttons |
| Объединенный тип | Flush gasketed wall plate with sealed actuators and supervised rear controller terminal connection |
| Customization | Доступно в зависимости от предполагаемого применения и операционной среды. |
Доступные варианты
Call, reset and emergency functionsSingle-room or networked annunciationAudible and visual confirmationPull-cord or wall-button input
Planning a Cleanroom Call System specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
