Cleanroom call system station with large red sealed button and confirmation light

Cleanroom Lighting dan Peralatan Listrik

Cleanroom Call System Sistem Panggilan

A supervised call-and-confirmation system that lets cleanroom personnel request assistance through large sealed wall buttons.

Large Sealed Call Button
Visible Call Confirmation
Supervised Control Circuit
Remote Acknowledge and Reset

Permintaan untuk kutipan Browse Produk

Perkenalan produk

The cleanroom call system connects flush wall call points to corridor indicators, an operator annunciator or a network server. A large colored membrane or stainless push button registers the request and illuminates to confirm it was received. Separate acknowledge and reset logic prevents a call from disappearing silently, while supervised wiring reports open-circuit or device faults.

Fitur utama:

The broad call control can be operated through double gloves.

A colored illuminated ring confirms that the system recorded the request.

Supervised wiring distinguishes a real call from a broken connection.

Remote annunciation identifies the originating room or call point.

Defined acknowledge and reset stages keep active requests visible until handled.

Kekhawatiran produk pelanggan

A simple push button is insufficient when users need confirmation, room identification and assurance that a broken wire has not disabled the call path.

A small button is hard to locate and press through gloves.A large high-contrast sealed actuator provides an obvious tactile target.

The caller cannot tell whether the signal reached an operator.A local light and optional tone confirm registration immediately.

A cable fault looks the same as a quiet inactive system.Supervised inputs raise a distinct trouble condition for open or short circuits.

Calls are cleared before assistance actually arrives.Separate acknowledge and local reset steps preserve the request workflow.

Aplikasi yang Tipis

Cleanroom assistance requestsGowning room support callsLaboratory emergency pointsMaterial airlock pickup calls

Parameter teknis

Typical configurable construction ranges for a cleanroom call system are listed below.

Bahan inti	Stainless flush plates with sealed call/reset controls, LED indicators, supervised controller and low-voltage wiring
Ketebalan Panel (Panel Thickness)	1.5-3.0 mm cleanroom call-point plate thickness
Efektif lebar	86-240 mm call-station face width
Panjang maksimum	Up to 320 mm overall station height
Baja menghadap ketebalan	1.5-3.0 mm SUS304/SUS316L front plate
Kepadatan inti (core density)	Approximately 7900-8000 kg/m³ for the stainless call-point plate
Konduktivitas Termal (Thermal Conductivity)	14-16 W/(m·K) for the stainless front plate
Permukaan selesai	Fine-brushed stainless with red, blue, green or amber illuminated sealed buttons
Jenis Bersama	Flush gasketed wall plate with sealed actuators and supervised rear controller terminal connection
Customization (Kustomisasi)	Tersedia berdasarkan aplikasi yang dimaksudkan dan lingkungan operasi.

Pilihan yang tersedia

Call, reset and emergency functionsSingle-room or networked annunciationAudible and visual confirmationPull-cord or wall-button input

Planning a Cleanroom Call System specification?

Kirimkan kami dimensi Anda, kondisi instalasi, target kinerja dan permukaan akhir yang diperlukan.

Bicaralah dengan tim kami