Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Éclairage de salle blanche et équipements électriques
Système d'appel Cleanroom
A supervised call-and-confirmation system that lets cleanroom personnel request assistance through large sealed wall buttons.
- Large Sealed Call Button
- Visible Call Confirmation
- Supervised Control Circuit
- Remote Acknowledge and Reset
Introduction de produit
The cleanroom call system connects flush wall call points to corridor indicators, an operator annunciator or a network server. A large colored membrane or stainless push button registers the request and illuminates to confirm it was received. Separate acknowledge and reset logic prevents a call from disappearing silently, while supervised wiring reports open-circuit or device faults.
Key Features
A colored illuminated ring confirms that the system recorded the request.
Supervised wiring distinguishes a real call from a broken connection.
Remote annunciation identifies the originating room or call point.
Defined acknowledge and reset stages keep active requests visible until handled.
Préoccupations du client produit
A simple push button is insufficient when users need confirmation, room identification and assurance that a broken wire has not disabled the call path.
A small button is hard to locate and press through gloves.A large high-contrast sealed actuator provides an obvious tactile target.
The caller cannot tell whether the signal reached an operator.A local light and optional tone confirm registration immediately.
A cable fault looks the same as a quiet inactive system.Supervised inputs raise a distinct trouble condition for open or short circuits.
Calls are cleared before assistance actually arrives.Separate acknowledge and local reset steps preserve the request workflow.
Les applications typiques
Cleanroom assistance requestsGowning room support callsLaboratory emergency pointsMaterial airlock pickup calls
Paramètres techniques
Typical configurable construction ranges for a cleanroom call system are listed below.
| Matériaux de base | Stainless flush plates with sealed call/reset controls, LED indicators, supervised controller and low-voltage wiring |
|---|---|
| Panneau épaisseur | 1.5-3.0 mm cleanroom call-point plate thickness |
| Largeur effective | 86-240 mm call-station face width |
| Longueur maximale | Up to 320 mm overall station height |
| Acier face épaisseur | 1.5-3.0 mm SUS304/SUS316L front plate |
| Densité Core | Approximately 7900-8000 kg/m³ for the stainless call-point plate |
| Conductivité thermique | 14-16 W/(m·K) for the stainless front plate |
| surface finie | Fine-brushed stainless with red, blue, green or amber illuminated sealed buttons |
| Type joint | Flush gasketed wall plate with sealed actuators and supervised rear controller terminal connection |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
Call, reset and emergency functionsSingle-room or networked annunciationAudible and visual confirmationPull-cord or wall-button input
Planning a Cleanroom Call System specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
