Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Iluminación de sala limpia y equipos eléctricos
Sistema de llamadas limpias
A supervised call-and-confirmation system that lets cleanroom personnel request assistance through large sealed wall buttons.
- Large Sealed Call Button
- Visible Call Confirmation
- Supervised Control Circuit
- Remote Acknowledge and Reset
Introducción del producto
The cleanroom call system connects flush wall call points to corridor indicators, an operator annunciator or a network server. A large colored membrane or stainless push button registers the request and illuminates to confirm it was received. Separate acknowledge and reset logic prevents a call from disappearing silently, while supervised wiring reports open-circuit or device faults.
Características clave
A colored illuminated ring confirms that the system recorded the request.
Supervised wiring distinguishes a real call from a broken connection.
Remote annunciation identifies the originating room or call point.
Defined acknowledge and reset stages keep active requests visible until handled.
Preocupaciones del producto del cliente
A simple push button is insufficient when users need confirmation, room identification and assurance that a broken wire has not disabled the call path.
A small button is hard to locate and press through gloves.A large high-contrast sealed actuator provides an obvious tactile target.
The caller cannot tell whether the signal reached an operator.A local light and optional tone confirm registration immediately.
A cable fault looks the same as a quiet inactive system.Supervised inputs raise a distinct trouble condition for open or short circuits.
Calls are cleared before assistance actually arrives.Separate acknowledge and local reset steps preserve the request workflow.
Aplicaciones típicas
Cleanroom assistance requestsGowning room support callsLaboratory emergency pointsMaterial airlock pickup calls
Parámetros técnicos
Typical configurable construction ranges for a cleanroom call system are listed below.
| Materiales Core | Stainless flush plates with sealed call/reset controls, LED indicators, supervised controller and low-voltage wiring |
|---|---|
| Panel de espesor | 1.5-3.0 mm cleanroom call-point plate thickness |
| Ancho efectivo | 86-240 mm call-station face width |
| Longitud máxima | Up to 320 mm overall station height |
| Acero frente a espesor | 1.5-3.0 mm SUS304/SUS316L front plate |
| Densidad Core | Approximately 7900-8000 kg/m³ for the stainless call-point plate |
| Conductividad térmica | 14-16 W/(m·K) for the stainless front plate |
| Superficie acabada | Fine-brushed stainless with red, blue, green or amber illuminated sealed buttons |
| Tipo conjunto | Flush gasketed wall plate with sealed actuators and supervised rear controller terminal connection |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Opciones disponibles
Call, reset and emergency functionsSingle-room or networked annunciationAudible and visual confirmationPull-cord or wall-button input
Planning a Cleanroom Call System specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
