Cleanroom light switch with flush stainless plate and sealed white actuator

Iluminação de sala limpa e equipamentos elétricos

Z Switch de luz para sala limpa

A low-profile wall switch that combines a wipe-clean actuator with a flush gasketed plate and enclosed wiring box.

Sealed Wipe-Clean Actuator
Flush Stainless Plate
Clear Circuit Identification
Enclosed Rear Terminals

Introdução do produto

This switch presents a sealed rocker, membrane key or touch surface within a stainless cleanroom plate. The broad flange closes the wall opening and the rear box contains terminals away from the room cavity. Laser-etched function labels and a small status indicator can be incorporated without applied paper labels or projecting pilot devices.

Características-chave

A membrane or gasketed rocker prevents an open slot around the moving control.

The flush plate aligns with modular wall panels for direct wiping.

Permanent engraving identifies the controlled lighting zone.

An optional indicator shows circuit state without a separate wall penetration.

The enclosed rear mechanism protects terminal screws from cleaning moisture.

Preocupações do produto do cliente

A wall switch is touched frequently and must remain readable, sealed and operable with cleanroom gloves.

Narrow rocker gaps accumulate skin oils and disinfectant.A continuous membrane or sealed actuator removes the open perimeter slot.

Printed adhesive labels peel after chemical cleaning.Laser engraving provides permanent circuit identification.

Small switches are difficult to operate through gloves.A broad tactile actuator provides a clear positive response.

Cleaning fluid reaches exposed rear terminals.A sealed rear box and gland enclose the wiring connection.

Aplicações típicas

Local cleanroom lighting switchingAirlock local switchingLaboratory task-light circuitsMaintenance override points

Parâmetros técnicos

Typical configurable construction ranges for a cleanroom light switch are listed below.

Material principal	Stainless front plate with sealed polymer membrane or rocker, switch mechanism and enclosed steel back box
Painel de espessura	1.5-3.0 mm room-side plate thickness
Largura efetiva	86-200 mm front-plate width
Comprimento máximo	Up to 260 mm plate height for multi-control layouts
Aço enfrentando espessura	1.5-3.0 mm SUS304 or SUS316L front plate
Densidade Core	Approximately 7900-8000 kg/m³ for the stainless front plate
Condutividade térmica	14-16 W/(m·K) for the stainless plate
Superfície acabado	Fine-brushed stainless or white coated face with engraved legends and colored indicator
Tipo conjunto	Flush plate with concealed gasket, sealed actuator and gland-connected rear switch box
Customização	Disponível com base na aplicação pretendida e no ambiente operacional.

Opções disponíveis

Single or multi-gang controlMembrane, rocker or capacitive touchIlluminated status indicatorMomentary or maintained contact

Planning a Cleanroom Light Switch specification?

Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.

Fale com a nossa equipe