Cleanroom light switch with flush stainless plate and sealed white actuator

クリーンルーム照明 · 電気機器

クリーンルームライトスイッチ

A low-profile wall switch that combines a wipe-clean actuator with a flush gasketed plate and enclosed wiring box.

Sealed Wipe-Clean Actuator
Flush Stainless Plate
Clear Circuit Identification
Enclosed Rear Terminals

商品紹介

This switch presents a sealed rocker, membrane key or touch surface within a stainless cleanroom plate. The broad flange closes the wall opening and the rear box contains terminals away from the room cavity. Laser-etched function labels and a small status indicator can be incorporated without applied paper labels or projecting pilot devices.

主要な特徴

A membrane or gasketed rocker prevents an open slot around the moving control.

The flush plate aligns with modular wall panels for direct wiping.

Permanent engraving identifies the controlled lighting zone.

An optional indicator shows circuit state without a separate wall penetration.

The enclosed rear mechanism protects terminal screws from cleaning moisture.

お客様の製品に関する懸念事項

A wall switch is touched frequently and must remain readable, sealed and operable with cleanroom gloves.

Narrow rocker gaps accumulate skin oils and disinfectant.A continuous membrane or sealed actuator removes the open perimeter slot.

Printed adhesive labels peel after chemical cleaning.Laser engraving provides permanent circuit identification.

Small switches are difficult to operate through gloves.A broad tactile actuator provides a clear positive response.

Cleaning fluid reaches exposed rear terminals.A sealed rear box and gland enclose the wiring connection.

典型的な用途

Local cleanroom lighting switchingAirlock local switchingLaboratory task-light circuitsMaintenance override points

技術的なパラメータ

Typical configurable construction ranges for a cleanroom light switch are listed below.

コア材料	Stainless front plate with sealed polymer membrane or rocker, switch mechanism and enclosed steel back box
パネルの厚さ	1.5-3.0 mm room-side plate thickness
有効幅	86-200 mm front-plate width
最大長さ	Up to 260 mm plate height for multi-control layouts
鋼鉄の厚さを直面する	1.5-3.0 mm SUS304 or SUS316L front plate
コア密度	Approximately 7900-8000 kg/m³ for the stainless front plate
熱伝導率	14-16 W/(m·K) for the stainless plate
表面仕上げ	Fine-brushed stainless or white coated face with engraved legends and colored indicator
ジョイントタイプ	Flush plate with concealed gasket, sealed actuator and gland-connected rear switch box
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Single or multi-gang controlMembrane, rocker or capacitive touchIlluminated status indicatorMomentary or maintained contact

Planning a Cleanroom Light Switch specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する