English
الألمانية
العربيةالحالي
الفرنسية
الإندونيسية
اليابانية
الكورية
اللغة الملاوية
البرتغالية
الروسية
الإسبانية
التايلاندية
اللغة التركية
اللغة الفيتنامية
إضاءة الغرف النظيفة والمعدات الكهربائية
مركز التحكم في المحركات
A floor-standing assembly that groups starters, protection, variable-speed drives and feeder controls for multiple cleanroom utility motors.
- Compartmentalized Motor Feeders
- Common Horizontal Bus
- Withdrawable or Fixed Units
- Networked Motor Monitoring
مقدمة المنتج
The motor control center combines multiple vertical sections around a common bus and cable system. Each motor feeder can contain isolation, short-circuit protection, contactor or drive, overload relay and control terminals in a dedicated compartment. Door-mounted status devices and an industrial network make pump and fan conditions visible without opening the power sections.
الخصائص الرئيسية
A common bus distributes incoming power across aligned vertical sections.
Separated wireways route field cables away from energized bus compartments.
Door-mounted status and local controls remain accessible with the section closed.
Networked protection devices expose current, trip and operating data to plant controls.
مخاوف المنتج للعملاء
A facility with many motors needs centralized protection and visibility without turning one service event into a shutdown of the entire utility system.
Scattered starters make isolation and troubleshooting inconsistent.Standard feeder compartments centralize protection, control and labeling.
Field cables cross buswork and complicate safe maintenance.Dedicated vertical and horizontal wireways segregate cable routes.
One failed starter interrupts adjacent motor controls during repair.Compartmentalized fixed or withdrawable units isolate the affected feeder.
Operators lack early warning before a motor protection trip.Intelligent relays report load, thermal state and trip history over the control network.
تطبيقات نموذجية
Air-handling unit motorsChilled-water pump motor feedersExhaust and pressure-control fansClean utility skids
المعلمات الفنية
Typical configurable construction ranges for a motor control center are listed below.
| المواد الأساسية | Powder-coated steel or stainless sections with copper bus, motor starters, protection relays and segregated wireways |
|---|---|
| سمك اللوحة | 400-600 mm cabinet section depth |
| العرض الفعال | 500-1000 mm per vertical section |
| الحد الأقصى الطول | Up to 2400 mm assembled section height |
| الصلب يواجه سمك | 1.5-2.5 mm section frame, panels and compartment doors |
| الكثافة الأساسية | Approximately 7850 kg/m³ for the structural carbon-steel sections |
| الموصلية الحرارية | 45-60 W/(m·K) for carbon-steel enclosure material |
| إنهاء السطح | Light-grey powder-coated sections with black handles and colored feeder status indicators |
| نوع المشترك | Bolted modular sections with gasketed compartment doors, common bus joints and segregated cable chambers |
| التخصيص | متوفر على أساس التطبيق المقصود وبيئة التشغيل. |
الخيارات المتاحة
Fixed or withdrawable feeder unitsContactor, soft starter or VFD feedersIntelligent motor protection relaysStainless outer enclosure
Planning a Motor Control Center specification?
أرسل لنا الأبعاد الخاصة بك، شروط التثبيت، أهداف الأداء والتشطيب السطحي المطلوب.
