Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Éclairage de salle blanche et équipements électriques
Z Centre de contrôle du moteur par
A floor-standing assembly that groups starters, protection, variable-speed drives and feeder controls for multiple cleanroom utility motors.
- Compartmentalized Motor Feeders
- Common Horizontal Bus
- Withdrawable or Fixed Units
- Networked Motor Monitoring
Introduction de produit
The motor control center combines multiple vertical sections around a common bus and cable system. Each motor feeder can contain isolation, short-circuit protection, contactor or drive, overload relay and control terminals in a dedicated compartment. Door-mounted status devices and an industrial network make pump and fan conditions visible without opening the power sections.
Key Features
A common bus distributes incoming power across aligned vertical sections.
Separated wireways route field cables away from energized bus compartments.
Door-mounted status and local controls remain accessible with the section closed.
Networked protection devices expose current, trip and operating data to plant controls.
Préoccupations du client produit
A facility with many motors needs centralized protection and visibility without turning one service event into a shutdown of the entire utility system.
Scattered starters make isolation and troubleshooting inconsistent.Standard feeder compartments centralize protection, control and labeling.
Field cables cross buswork and complicate safe maintenance.Dedicated vertical and horizontal wireways segregate cable routes.
One failed starter interrupts adjacent motor controls during repair.Compartmentalized fixed or withdrawable units isolate the affected feeder.
Operators lack early warning before a motor protection trip.Intelligent relays report load, thermal state and trip history over the control network.
Les applications typiques
Air-handling unit motorsChilled-water pump motor feedersExhaust and pressure-control fansClean utility skids
Paramètres techniques
Typical configurable construction ranges for a motor control center are listed below.
| Matériaux de base | Powder-coated steel or stainless sections with copper bus, motor starters, protection relays and segregated wireways |
|---|---|
| Panneau épaisseur | 400-600 mm cabinet section depth |
| Largeur effective | 500-1000 mm per vertical section |
| Longueur maximale | Up to 2400 mm assembled section height |
| Acier face épaisseur | 1.5-2.5 mm section frame, panels and compartment doors |
| Densité Core | Approximately 7850 kg/m³ for the structural carbon-steel sections |
| Conductivité thermique | 45-60 W/(m·K) for carbon-steel enclosure material |
| surface finie | Light-grey powder-coated sections with black handles and colored feeder status indicators |
| Type joint | Bolted modular sections with gasketed compartment doors, common bus joints and segregated cable chambers |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
Fixed or withdrawable feeder unitsContactor, soft starter or VFD feedersIntelligent motor protection relaysStainless outer enclosure
Planning a Motor Control Center specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
