Complete multi-section motor control center with light-grey compartment doors

クリーンルーム照明 · 電気機器

モーター制御センター

A floor-standing assembly that groups starters, protection, variable-speed drives and feeder controls for multiple cleanroom utility motors.

Compartmentalized Motor Feeders
Common Horizontal Bus
Withdrawable or Fixed Units
Networked Motor Monitoring

見積もりリクエスト製品案内

商品紹介

The motor control center combines multiple vertical sections around a common bus and cable system. Each motor feeder can contain isolation, short-circuit protection, contactor or drive, overload relay and control terminals in a dedicated compartment. Door-mounted status devices and an industrial network make pump and fan conditions visible without opening the power sections.

主要な特徴

Individual feeder compartments localize service work to one motor circuit.

A common bus distributes incoming power across aligned vertical sections.

Separated wireways route field cables away from energized bus compartments.

Door-mounted status and local controls remain accessible with the section closed.

Networked protection devices expose current, trip and operating data to plant controls.

お客様の製品に関する懸念事項

A facility with many motors needs centralized protection and visibility without turning one service event into a shutdown of the entire utility system.

Scattered starters make isolation and troubleshooting inconsistent.Standard feeder compartments centralize protection, control and labeling.

Field cables cross buswork and complicate safe maintenance.Dedicated vertical and horizontal wireways segregate cable routes.

One failed starter interrupts adjacent motor controls during repair.Compartmentalized fixed or withdrawable units isolate the affected feeder.

Operators lack early warning before a motor protection trip.Intelligent relays report load, thermal state and trip history over the control network.

典型的な用途

Air-handling unit motorsChilled-water pump motor feedersExhaust and pressure-control fansClean utility skids

技術的なパラメータ

Typical configurable construction ranges for a motor control center are listed below.

コア材料	Powder-coated steel or stainless sections with copper bus, motor starters, protection relays and segregated wireways
パネルの厚さ	400-600 mm cabinet section depth
有効幅	500-1000 mm per vertical section
最大長さ	Up to 2400 mm assembled section height
鋼鉄の厚さを直面する	1.5-2.5 mm section frame, panels and compartment doors
コア密度	Approximately 7850 kg/m³ for the structural carbon-steel sections
熱伝導率	45-60 W/(m·K) for carbon-steel enclosure material
表面仕上げ	Light-grey powder-coated sections with black handles and colored feeder status indicators
ジョイントタイプ	Bolted modular sections with gasketed compartment doors, common bus joints and segregated cable chambers
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

Fixed or withdrawable feeder unitsContactor, soft starter or VFD feedersIntelligent motor protection relaysStainless outer enclosure

Planning a Motor Control Center specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する