Complete cleanroom stainless electrical conduit route with swept bend and fittings

Temiz Oda Aydınlatma ve Elektrik Ekipmanları

Temiz Oda Elektrik Borusu

A smooth enclosed cable route using sealed tube, couplings and penetration fittings for exposed cleanroom electrical services.

Smooth Enclosed Cable Route
Sealed Compression Couplings
Hygienic Support Clips
Gasketed Wall Penetrations

Alıntı isteği Browse ürünleri

Ürün tanıtımı

Cleanroom conduit encloses conductors inside stainless or coated metal tube and connects each section with compression or threaded fittings. Low-profile clips hold the route away from walls only where cleaning access is required, while sanitary escutcheons or bulkhead fittings close penetrations through cleanroom panels. Swept bends preserve cable pulling radius without open junctions.

Ana Özellikler

The closed tube protects cables and removes loose bundles from the cleaning surface.

Compression or threaded couplings maintain continuity through each straight joint.

Swept bends reduce pulling stress on control and power conductors.

Smooth support clips avoid deep saddles and exposed sharp threads.

Sealed bulkhead fittings close the wall around each conduit penetration.

Müşteri Ürün Sorunları

An exposed cable route must remain enclosed and continuous through bends, supports and panel penetrations, not only along the straight tube.

Loose cables sag and create irregular surfaces above equipment.Rigid conduit maintains a defined enclosed route.

Ordinary set-screw couplings leave open seams.Compression or threaded sealed fittings close the tube joint.

Tight elbows damage data cable during pulling.Large-radius swept bends preserve the conductor bend requirement.

A conduit hole bypasses the cleanroom wall seal.A gasketed bulkhead fitting clamps both sides of the panel penetration.

Tipik uygulamalar

Exposed cleanroom power routesInstrument cable protectionEquipment service dropsWall and ceiling crossings

Teknik parametreler

Typical configurable construction ranges for cleanroom electrical conduit are listed below.

Temel malzemeler	SUS304/SUS316L or coated steel conduit with compression fittings, swept bends and sanitary bulkhead seals
Panel kalınlığı	1.0-2.0 mm conduit wall thickness
Effective Width (Etkili Genişlik)	16-63 mm nominal conduit diameter
Maksimum uzunluk	Up to 6000 mm per straight tube section
Çelik yüz yüze kalınlığı	1.0-2.0 mm stainless or steel tube wall
Core Density (Çekirdek Yoğunluğu)	Approximately 7900-8000 kg/m³ for stainless conduit material
Termal İletkenlik	14-16 W/(m·K) for stainless tube
Yüzey bitirme	Fine-brushed, electropolished or smooth white-coated exterior
Ortak tip	Threaded or compression-sealed conduit couplings with gasketed panel bulkhead fittings
Customization (Özelleşme)	Kullanılan uygulama ve çalışma ortamına göre kullanılabilir.

Mevcut Seçenekler

Rigid stainless or coated steelFlexible liquid-tight equipment tailThreaded or compression fittingsWall, ceiling and floor bulkheads

Planning a Cleanroom Electrical Conduit specification?

Bize boyutlarınızı, montaj koşullarınızı, performans hedeflerinizi ve gerekli yüzey kaplamalarınızı gönderin.

Ekibimizle konuşun