Complete cleanroom stainless electrical conduit route with swept bend and fittings

클린룸 조명 및 전기 장비

클린룸 전기 덕트

A smooth enclosed cable route using sealed tube, couplings and penetration fittings for exposed cleanroom electrical services.

Smooth Enclosed Cable Route
Sealed Compression Couplings
Hygienic Support Clips
Gasketed Wall Penetrations

견적 요청 제품 찾아보기

상품 소개

Cleanroom conduit encloses conductors inside stainless or coated metal tube and connects each section with compression or threaded fittings. Low-profile clips hold the route away from walls only where cleaning access is required, while sanitary escutcheons or bulkhead fittings close penetrations through cleanroom panels. Swept bends preserve cable pulling radius without open junctions.

주요 기능

The closed tube protects cables and removes loose bundles from the cleaning surface.

Compression or threaded couplings maintain continuity through each straight joint.

Swept bends reduce pulling stress on control and power conductors.

Smooth support clips avoid deep saddles and exposed sharp threads.

Sealed bulkhead fittings close the wall around each conduit penetration.

고객 제품 관심사

An exposed cable route must remain enclosed and continuous through bends, supports and panel penetrations, not only along the straight tube.

Loose cables sag and create irregular surfaces above equipment.Rigid conduit maintains a defined enclosed route.

Ordinary set-screw couplings leave open seams.Compression or threaded sealed fittings close the tube joint.

Tight elbows damage data cable during pulling.Large-radius swept bends preserve the conductor bend requirement.

A conduit hole bypasses the cleanroom wall seal.A gasketed bulkhead fitting clamps both sides of the panel penetration.

일반적인 응용 프로그램

Exposed cleanroom power routesInstrument cable protectionEquipment service dropsWall and ceiling crossings

기술 매개변수

Typical configurable construction ranges for cleanroom electrical conduit are listed below.

핵심 재료	SUS304/SUS316L or coated steel conduit with compression fittings, swept bends and sanitary bulkhead seals
패널 두께	1.0-2.0 mm conduit wall thickness
유효 폭	16-63 mm nominal conduit diameter
최대 길이	Up to 6000 mm per straight tube section
강철 면면 두께	1.0-2.0 mm stainless or steel tube wall
코어 밀도	Approximately 7900-8000 kg/m³ for stainless conduit material
열전도도 (Thermal Conductivity)	14-16 W/(m·K) for stainless tube
표면 마무리	Fine-brushed, electropolished or smooth white-coated exterior
접합 유형	Threaded or compression-sealed conduit couplings with gasketed panel bulkhead fittings
사용자 정의	의도된 응용 프로그램 및 운영 환경에 따라 사용할 수 있습니다.

사용 가능한 옵션

Rigid stainless or coated steelFlexible liquid-tight equipment tailThreaded or compression fittingsWall, ceiling and floor bulkheads

Planning a Cleanroom Electrical Conduit specification?

치수, 설치 조건, 성능 목표 및 필요한 표면 마감을 보내십시오.

우리 팀과 대화하십시오.