Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Éclairage de salle blanche et équipements électriques
Cleanroom conduit électrique
A smooth enclosed cable route using sealed tube, couplings and penetration fittings for exposed cleanroom electrical services.
- Smooth Enclosed Cable Route
- Sealed Compression Couplings
- Hygienic Support Clips
- Gasketed Wall Penetrations
Introduction de produit
Cleanroom conduit encloses conductors inside stainless or coated metal tube and connects each section with compression or threaded fittings. Low-profile clips hold the route away from walls only where cleaning access is required, while sanitary escutcheons or bulkhead fittings close penetrations through cleanroom panels. Swept bends preserve cable pulling radius without open junctions.
Key Features
Compression or threaded couplings maintain continuity through each straight joint.
Swept bends reduce pulling stress on control and power conductors.
Smooth support clips avoid deep saddles and exposed sharp threads.
Sealed bulkhead fittings close the wall around each conduit penetration.
Préoccupations du client produit
An exposed cable route must remain enclosed and continuous through bends, supports and panel penetrations, not only along the straight tube.
Loose cables sag and create irregular surfaces above equipment.Rigid conduit maintains a defined enclosed route.
Ordinary set-screw couplings leave open seams.Compression or threaded sealed fittings close the tube joint.
Tight elbows damage data cable during pulling.Large-radius swept bends preserve the conductor bend requirement.
A conduit hole bypasses the cleanroom wall seal.A gasketed bulkhead fitting clamps both sides of the panel penetration.
Les applications typiques
Exposed cleanroom power routesInstrument cable protectionEquipment service dropsWall and ceiling crossings
Paramètres techniques
Typical configurable construction ranges for cleanroom electrical conduit are listed below.
| Matériaux de base | SUS304/SUS316L or coated steel conduit with compression fittings, swept bends and sanitary bulkhead seals |
|---|---|
| Panneau épaisseur | 1.0-2.0 mm conduit wall thickness |
| Largeur effective | 16-63 mm nominal conduit diameter |
| Longueur maximale | Up to 6000 mm per straight tube section |
| Acier face épaisseur | 1.0-2.0 mm stainless or steel tube wall |
| Densité Core | Approximately 7900-8000 kg/m³ for stainless conduit material |
| Conductivité thermique | 14-16 W/(m·K) for stainless tube |
| surface finie | Fine-brushed, electropolished or smooth white-coated exterior |
| Type joint | Threaded or compression-sealed conduit couplings with gasketed panel bulkhead fittings |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
Rigid stainless or coated steelFlexible liquid-tight equipment tailThreaded or compression fittingsWall, ceiling and floor bulkheads
Planning a Cleanroom Electrical Conduit specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
