Inglés
Alemán
El árabe
Francés
Idioma indonesio
El japonés
Coreano
El malayo
El portugués
El ruso
EspañolCurrent
Tailandés
El turco
El vietnamita
Iluminación de sala limpia y equipos eléctricos
Conductor eléctrico de sala limpia
A smooth enclosed cable route using sealed tube, couplings and penetration fittings for exposed cleanroom electrical services.
- Smooth Enclosed Cable Route
- Sealed Compression Couplings
- Hygienic Support Clips
- Gasketed Wall Penetrations
Introducción del producto
Cleanroom conduit encloses conductors inside stainless or coated metal tube and connects each section with compression or threaded fittings. Low-profile clips hold the route away from walls only where cleaning access is required, while sanitary escutcheons or bulkhead fittings close penetrations through cleanroom panels. Swept bends preserve cable pulling radius without open junctions.
Características clave
Compression or threaded couplings maintain continuity through each straight joint.
Swept bends reduce pulling stress on control and power conductors.
Smooth support clips avoid deep saddles and exposed sharp threads.
Sealed bulkhead fittings close the wall around each conduit penetration.
Preocupaciones del producto del cliente
An exposed cable route must remain enclosed and continuous through bends, supports and panel penetrations, not only along the straight tube.
Loose cables sag and create irregular surfaces above equipment.Rigid conduit maintains a defined enclosed route.
Ordinary set-screw couplings leave open seams.Compression or threaded sealed fittings close the tube joint.
Tight elbows damage data cable during pulling.Large-radius swept bends preserve the conductor bend requirement.
A conduit hole bypasses the cleanroom wall seal.A gasketed bulkhead fitting clamps both sides of the panel penetration.
Aplicaciones típicas
Exposed cleanroom power routesInstrument cable protectionEquipment service dropsWall and ceiling crossings
Parámetros técnicos
Typical configurable construction ranges for cleanroom electrical conduit are listed below.
| Materiales Core | SUS304/SUS316L or coated steel conduit with compression fittings, swept bends and sanitary bulkhead seals |
|---|---|
| Panel de espesor | 1.0-2.0 mm conduit wall thickness |
| Ancho efectivo | 16-63 mm nominal conduit diameter |
| Longitud máxima | Up to 6000 mm per straight tube section |
| Acero frente a espesor | 1.0-2.0 mm stainless or steel tube wall |
| Densidad Core | Approximately 7900-8000 kg/m³ for stainless conduit material |
| Conductividad térmica | 14-16 W/(m·K) for stainless tube |
| Superficie acabada | Fine-brushed, electropolished or smooth white-coated exterior |
| Tipo conjunto | Threaded or compression-sealed conduit couplings with gasketed panel bulkhead fittings |
| Customization | Disponible según la aplicación prevista y el entorno operativo. |
Opciones disponibles
Rigid stainless or coated steelFlexible liquid-tight equipment tailThreaded or compression fittingsWall, ceiling and floor bulkheads
Planning a Cleanroom Electrical Conduit specification?
Envíenos sus dimensiones, condiciones de instalación, objetivos de rendimiento y acabado superficial requerido.
