Three-quarter view of a stainless cleanroom panel clamp gripping two sandwich-panel edges

Acessórios de instalação de sala limpa

Sala limpa Panel Clamp

A reusable stainless-steel bridge clamp that holds adjacent sandwich-panel edges in alignment while their joint is fixed and sealed.

Reusable Installation Tool
Opposed Edge Jaws
Threaded Force Control
No Permanent Face Fixing

Solicite um orçamento. Browse produtos

Introdução do produto

The cleanroom panel clamp is an external installation tool with opposed formed jaws and a threaded adjuster. The jaws bear on protected panel edges while the screw draws adjacent sandwich panels into a stable working position. Installers can therefore check face alignment, close the joint and complete concealed fixing before removing the clamp, without leaving the tool as part of the finished enclosure.

Características-chave

Opposed hooked jaws engage both panel edges without relying on a permanent surface fastener.

A coarse threaded adjuster provides progressive, controllable closing force during alignment.

Stainless construction tolerates repeated handling and can be cleaned between installation areas.

Replaceable contact pads or protected jaw faces can reduce marking on coated steel skins.

Preocupações do produto do cliente

Lightweight insulated panels can move or develop a face step before concealed joint hardware and sealant have secured the assembly.

Two panel faces drift out of plane while the concealed fixing is tightened.The bridge clamp holds both edges against a common jaw position during fastening.

Uncontrolled leverage can dent thin coated-steel facings.Threaded adjustment applies force gradually, with jaw pads selected for the facing finish.

Temporary screws leave holes that require hygienic repair.External jaws grip removable edge locations without adding permanent face penetrations.

Different panel thicknesses make a fixed-gap tool impractical.Jaw reach, bridge width and screw travel can be matched to the installed panel system.

Aplicações típicas

Cleanroom wall-panel erectionCeiling panel edge alignmentModular enclosure assemblyJoint sealing preparationDoor and window infill installation

Parâmetros técnicos

Typical construction ranges for a reusable stainless cleanroom sandwich-panel alignment clamp are listed below.

Material principal	304 stainless-steel bridge, opposed formed jaws and threaded adjuster
Painel de espessura	50-150 mm compatible sandwich-panel thickness
Largura efetiva	60-240 mm adjustable jaw span
Comprimento máximo	Up to 500 mm overall clamp bridge length
Aço enfrentando espessura	2.00-6.00 mm structural clamp component thickness
Densidade Core	Approximately 7900-8000 kg/m³ for stainless-steel components
Condutividade térmica	Approximately 14-17 W/(m·K) for austenitic stainless steel
Superfície acabado	Brushed or bead-blasted stainless steel with optional non-marking jaw pads
Tipo conjunto	Removable opposed-jaw bridge clamp with threaded mechanical adjustment
Customização	Disponível com base na aplicação pretendida e no ambiente operacional.

Opções disponíveis

304 or 316 stainless steelSoft polymer jaw padsHex-bolt or hand-knob adjustmentCustom jaw reach and span

Planning a Cleanroom Panel Clamp specification?

Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.

Fale com a nossa equipe