Three-quarter view of a stainless cleanroom panel clamp gripping two sandwich-panel edges

Aksesori Pemasangan Bilik Bersih

Pengapit Panel Bilik Bersih

A reusable stainless-steel bridge clamp that holds adjacent sandwich-panel edges in alignment while their joint is fixed and sealed.

Reusable Installation Tool
Opposed Edge Jaws
Threaded Force Control
No Permanent Face Fixing

Permintaan sebut harga Semak imbas produk

Pengenalan Produk

The cleanroom panel clamp is an external installation tool with opposed formed jaws and a threaded adjuster. The jaws bear on protected panel edges while the screw draws adjacent sandwich panels into a stable working position. Installers can therefore check face alignment, close the joint and complete concealed fixing before removing the clamp, without leaving the tool as part of the finished enclosure.

Ciri-ciri Utama

Opposed hooked jaws engage both panel edges without relying on a permanent surface fastener.

A coarse threaded adjuster provides progressive, controllable closing force during alignment.

Stainless construction tolerates repeated handling and can be cleaned between installation areas.

Replaceable contact pads or protected jaw faces can reduce marking on coated steel skins.

Kebimbangan Produk Pelanggan

Lightweight insulated panels can move or develop a face step before concealed joint hardware and sealant have secured the assembly.

Two panel faces drift out of plane while the concealed fixing is tightened.The bridge clamp holds both edges against a common jaw position during fastening.

Uncontrolled leverage can dent thin coated-steel facings.Threaded adjustment applies force gradually, with jaw pads selected for the facing finish.

Temporary screws leave holes that require hygienic repair.External jaws grip removable edge locations without adding permanent face penetrations.

Different panel thicknesses make a fixed-gap tool impractical.Jaw reach, bridge width and screw travel can be matched to the installed panel system.

Permohonan yang biasa

Cleanroom wall-panel erectionCeiling panel edge alignmentModular enclosure assemblyJoint sealing preparationDoor and window infill installation

Parameter teknikal

Typical construction ranges for a reusable stainless cleanroom sandwich-panel alignment clamp are listed below.

Bahan Teras	304 stainless-steel bridge, opposed formed jaws and threaded adjuster
Ketebalan Panel	50-150 mm compatible sandwich-panel thickness
Lebar berkesan	60-240 mm adjustable jaw span
Panjang maksimum	Up to 500 mm overall clamp bridge length
Keluli Menghadapi Ketebalan	2.00-6.00 mm structural clamp component thickness
Ketumpatan teras	Approximately 7900-8000 kg/m³ for stainless-steel components
Kekonduksian Terma	Approximately 14-17 W/(m·K) for austenitic stainless steel
Kemasan permukaan	Brushed or bead-blasted stainless steel with optional non-marking jaw pads
Jenis Bersatu	Removable opposed-jaw bridge clamp with threaded mechanical adjustment
Penyesuaian	Boleh didapati berdasarkan aplikasi yang dimaksudkan dan persekitaran operasi.

Pilihan yang boleh didapati

304 or 316 stainless steelSoft polymer jaw padsHex-bolt or hand-knob adjustmentCustom jaw reach and span

Planning a Cleanroom Panel Clamp specification?

Hantarkan kepada kami dimensi anda, syarat pemasangan, sasaran prestasi dan kemasan permukaan yang diperlukan.

Berbincang dengan pasukan kami