Three-quarter view of a stainless cleanroom panel clamp gripping two sandwich-panel edges

クリーンルームの設置付属品

クリーンルームパネルクランプ

A reusable stainless-steel bridge clamp that holds adjacent sandwich-panel edges in alignment while their joint is fixed and sealed.

Reusable Installation Tool
Opposed Edge Jaws
Threaded Force Control
No Permanent Face Fixing

見積もりリクエスト製品案内

商品紹介

The cleanroom panel clamp is an external installation tool with opposed formed jaws and a threaded adjuster. The jaws bear on protected panel edges while the screw draws adjacent sandwich panels into a stable working position. Installers can therefore check face alignment, close the joint and complete concealed fixing before removing the clamp, without leaving the tool as part of the finished enclosure.

主要な特徴

Opposed hooked jaws engage both panel edges without relying on a permanent surface fastener.

A coarse threaded adjuster provides progressive, controllable closing force during alignment.

Stainless construction tolerates repeated handling and can be cleaned between installation areas.

Replaceable contact pads or protected jaw faces can reduce marking on coated steel skins.

お客様の製品に関する懸念事項

Lightweight insulated panels can move or develop a face step before concealed joint hardware and sealant have secured the assembly.

Two panel faces drift out of plane while the concealed fixing is tightened.The bridge clamp holds both edges against a common jaw position during fastening.

Uncontrolled leverage can dent thin coated-steel facings.Threaded adjustment applies force gradually, with jaw pads selected for the facing finish.

Temporary screws leave holes that require hygienic repair.External jaws grip removable edge locations without adding permanent face penetrations.

Different panel thicknesses make a fixed-gap tool impractical.Jaw reach, bridge width and screw travel can be matched to the installed panel system.

典型的な用途

Cleanroom wall-panel erectionCeiling panel edge alignmentModular enclosure assemblyJoint sealing preparationDoor and window infill installation

技術的なパラメータ

Typical construction ranges for a reusable stainless cleanroom sandwich-panel alignment clamp are listed below.

コア材料	304 stainless-steel bridge, opposed formed jaws and threaded adjuster
パネルの厚さ	50-150 mm compatible sandwich-panel thickness
有効幅	60-240 mm adjustable jaw span
最大長さ	Up to 500 mm overall clamp bridge length
鋼鉄の厚さを直面する	2.00-6.00 mm structural clamp component thickness
コア密度	Approximately 7900-8000 kg/m³ for stainless-steel components
熱伝導率	Approximately 14-17 W/(m·K) for austenitic stainless steel
表面仕上げ	Brushed or bead-blasted stainless steel with optional non-marking jaw pads
ジョイントタイプ	Removable opposed-jaw bridge clamp with threaded mechanical adjustment
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

304 or 316 stainless steelSoft polymer jaw padsHex-bolt or hand-knob adjustmentCustom jaw reach and span

Planning a Cleanroom Panel Clamp specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する