Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Filtros de ar e filtragem química
Filtro de bolso de carbono ativado
A multi-pocket filter combining particulate media with a distributed activated-carbon layer to remove fine dust and light-duty gaseous contaminants in one HVAC stage.
- Particle and Gas Filtration
- Conical Pocket Geometry
- Distributed Carbon Layer
- Large Media Surface
Introdução do produto
The activated carbon pocket filter combines an upstream particulate layer, a bonded activated-carbon layer and a stabilizing downstream support within multiple tapered pockets. The long pockets provide a much greater media area than a flat panel and distribute both particle loading and carbon adsorption over the airflow. Stitched or ultrasonically welded spacers keep the pockets separated, while a steel or molded-polymer header fits standard bag-filter housings. It is intended for indoor-air-quality duty where moderate odors and particulates must be addressed without installing two separate filter stages.
Características-chave
Tapered pockets remain separated at design flow and use the available housing depth efficiently.
The distributed carbon layer exposes adsorbent across a broad area instead of concentrating it near the header.
A rigid header provides a familiar replacement interface for standard front- or side-access bag-filter systems.
Preocupações do produto do cliente
Separate particle and molecular stages consume valuable air-handler length, yet a thin carbon panel may not provide enough active area for the required airflow.
The air handler lacks space for a particle filter followed by a separate carbon cassette.Composite pocket media combines both functions within one standard bag-filter stage.
Flat carbon media has too little exposed area at the system airflow.Multiple deep pockets increase the available carbon-coated surface behind the same face opening.
Bag pockets touch and block one another at reduced airflow.Tapered geometry and internal spacing retain open channels through the filter bank.
Particulate loading covers the carbon before its adsorption capacity is used.A dedicated upstream particle layer protects the distributed carbon surface from coarse dust.
Aplicações típicas
Commercial building supply airHospital general ventilationAirport and transport facilitiesLaboratory support-area HVACCleanroom prefiltration with odor control
Parâmetros técnicos
Representative construction ranges for a combination activated-carbon pocket filter are shown below.
| Material principal | Synthetic or glass-fibre particulate medium laminated with bonded activated-carbon media |
|---|---|
| Painel de espessura | 360–640 mm pocket depth |
| Largura efetiva | 287–592 mm nominal header width |
| Comprimento máximo | Up to 640 mm pocket length |
| Aço enfrentando espessura | 0.6–0.9 mm painted or galvanized-steel header frame when specified |
| Densidade Core | Approximately 80–160 kg/m³ equivalent composite-media density including bonded carbon |
| Condutividade térmica | Approximately 0.040–0.080 W/(m·K) for the dry composite pocket medium |
| Superfície acabado | Painted steel or molded polymer header with dark carbon-loaded pocket media |
| Tipo conjunto | Header-frame gasket or clamp-in pocket-filter connection |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Five to ten pocket configurationsSteel or incinerable polymer headerParticulate efficiency selected for the HVAC stageBroad-spectrum or impregnated carbon layer
Planning a Activated Carbon Pocket Filter specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
