Anglais
Allemand
Arabe
FrançaisCurrent
Indonésien
Japonais
Coréen
Le malais
Le portugais
russe
espagnol
Thaïlandais
Le turc
Le vietnamien
Filtres à air et filtration chimique
AFiltre à poche en carbone activé Filtre à charbon actif
A multi-pocket filter combining particulate media with a distributed activated-carbon layer to remove fine dust and light-duty gaseous contaminants in one HVAC stage.
- Particle and Gas Filtration
- Conical Pocket Geometry
- Distributed Carbon Layer
- Large Media Surface
Introduction de produit
The activated carbon pocket filter combines an upstream particulate layer, a bonded activated-carbon layer and a stabilizing downstream support within multiple tapered pockets. The long pockets provide a much greater media area than a flat panel and distribute both particle loading and carbon adsorption over the airflow. Stitched or ultrasonically welded spacers keep the pockets separated, while a steel or molded-polymer header fits standard bag-filter housings. It is intended for indoor-air-quality duty where moderate odors and particulates must be addressed without installing two separate filter stages.
Key Features
Tapered pockets remain separated at design flow and use the available housing depth efficiently.
The distributed carbon layer exposes adsorbent across a broad area instead of concentrating it near the header.
A rigid header provides a familiar replacement interface for standard front- or side-access bag-filter systems.
Préoccupations du client produit
Separate particle and molecular stages consume valuable air-handler length, yet a thin carbon panel may not provide enough active area for the required airflow.
The air handler lacks space for a particle filter followed by a separate carbon cassette.Composite pocket media combines both functions within one standard bag-filter stage.
Flat carbon media has too little exposed area at the system airflow.Multiple deep pockets increase the available carbon-coated surface behind the same face opening.
Bag pockets touch and block one another at reduced airflow.Tapered geometry and internal spacing retain open channels through the filter bank.
Particulate loading covers the carbon before its adsorption capacity is used.A dedicated upstream particle layer protects the distributed carbon surface from coarse dust.
Les applications typiques
Commercial building supply airHospital general ventilationAirport and transport facilitiesLaboratory support-area HVACCleanroom prefiltration with odor control
Paramètres techniques
Representative construction ranges for a combination activated-carbon pocket filter are shown below.
| Matériaux de base | Synthetic or glass-fibre particulate medium laminated with bonded activated-carbon media |
|---|---|
| Panneau épaisseur | 360–640 mm pocket depth |
| Largeur effective | 287–592 mm nominal header width |
| Longueur maximale | Up to 640 mm pocket length |
| Acier face épaisseur | 0.6–0.9 mm painted or galvanized-steel header frame when specified |
| Densité Core | Approximately 80–160 kg/m³ equivalent composite-media density including bonded carbon |
| Conductivité thermique | Approximately 0.040–0.080 W/(m·K) for the dry composite pocket medium |
| surface finie | Painted steel or molded polymer header with dark carbon-loaded pocket media |
| Type joint | Header-frame gasket or clamp-in pocket-filter connection |
| Customisation | Disponible en fonction de l'application prévue et de l'environnement d'exploitation. |
Options disponibles
Five to ten pocket configurationsSteel or incinerable polymer headerParticulate efficiency selected for the HVAC stageBroad-spectrum or impregnated carbon layer
Planning a Activated Carbon Pocket Filter specification?
Envoyez-nous vos dimensions, conditions d'installation, objectifs de performance et finition de surface requise.
