Cleanroom Garments, PPE and Consumables

Sterile Cleanroom Wipes

Sterile low-lint cleanroom wipes supplied in sealed transfer-ready packaging for controlled surface cleaning in aseptic processing areas.

Sterile supply supports wiping procedures in higher-control aseptic areas
Low-lint synthetic substrate provides clean wet strength
Double-barrier peel packaging simplifies controlled transfer between zones

Request a Quote Browse Products

Product Introduction

Sterile Cleanroom Wipes combine a low-lint polyester or polyester-blend substrate with a package configuration designed for transfer into controlled areas. The wipes may be supplied dry or pre-saturated, with small pack quantities reducing unnecessary exposure after opening. Clear double-barrier packaging and peelable seals support staged disinfection and entry while preserving the wipe stack until point of use.

Key Features

Sterile product configuration is available for aseptic cleaning programs

Synthetic low-lint fabric remains intact during wet wiping

Double-bag construction supports transfer through material airlocks

Peelable chevron end can be opened while wearing cleanroom gloves

Dry and pre-saturated chemistries can be matched to the cleaning procedure

Customer Product Concerns

Aseptic-area wipes must arrive in a protected package, remain easy to transfer and provide enough wet strength for the intended cleaning motion. Large open packs can also increase exposure and unused-product waste.

Packaging surfaces may carry contamination between classified zones.Use nested cleanroom-compatible bags with clear staged-transfer procedures.

Opened bulk packs can expose unused wipes before they are needed.Select a pack count aligned with one room, shift or cleaning task.

Weak substrates may tear during disinfectant application.Specify a synthetic wipe with dependable wet strength and low fiber release.

An unsuitable solution load can leave surfaces too wet or dry too quickly.Choose dry wipes or a validated pre-saturated configuration for the site's contact-time requirements.

Typical Applications

Used for disinfectant application, residue removal, wiping-to-dry and critical-site cleaning in pharmaceutical aseptic suites, compounding areas, biotechnology production, medical-device assembly and controlled laboratories.

Technical Parameters

The ranges below cover common sterile square wipe configurations. Substrate, pack count, sterilization method and pre-saturation chemistry are selected for the approved facility cleaning program.

Core Material	Low-lint knitted or nonwoven polyester wipe substrate
Panel Thickness	0.30–0.65 mm
Effective Width	100–310 mm
Maximum Length	310 mm
Steel Facing Thickness	0 mm; no steel facing used
Core Density	70–160 kg/m³ apparent fabric density
Thermal Conductivity	0.04–0.07 W/(m·K), substrate dependent
Surface Finish	White low-lint wipe in clear double-barrier peel packaging
Joint Type	Sealed cut-edge or sealed-edge wipe with heat-sealed package perimeter
Customization	Available based on the intended application and operating environment.

Available Options

Dry or pre-saturated formatKnitted polyester or hydroentangled nonwoven substrateSmall task packs or standard stack packsDouble- or triple-bag transfer packagingGamma-irradiated sterile configurationMultiple wipe sizes and edge finishes

Planning a Sterile Cleanroom Wipes specification?

Send us your dimensions, installation conditions, performance targets and required surface finish.

Talk to Our Team