Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Equipamento de manuseio de ar e HVAC para sala limpa
Torre de resfriamento de contrafluxo induzida
A compact evaporative heat-rejection tower that draws air upward through wetted fill while condenser water descends into an accessible collection basin.
- Counterflow Air-Water Contact
- Top-Mounted Induced Draft
- Corrosion-Resistant FRP Shell
- Serviceable Fill and Basin
Introdução do produto
The induced-draft counterflow tower uses a top axial fan to draw ambient air upward against warm condenser water distributed above the fill. Evaporation removes heat before cooled water collects in the lower basin and returns to the refrigeration plant. A square FRP casing, removable louvers and modular fill pack provide a compact alternative to crossflow arrangements where footprint matters.
Características-chave
The fan at the discharge draws air uniformly through lower inlet louvers and reduces recirculation at the intake.
FRP casing panels and stainless support members resist continuous wet service and treatment chemistry.
Access doors, removable fill cassettes and an open basin support inspection of water-contact components.
Preocupações do produto do cliente
A cooling tower must reject the design load while controlling footprint, water distribution and maintenance access.
Limited roof area restricts the size of heat-rejection equipment.A vertical counterflow path concentrates fill depth and fan discharge within a compact square plan.
Uneven spray distribution leaves dry fill zones and reduces capacity.A full-coverage header and serviceable nozzles wet the modular fill pack uniformly.
Drift can carry treatment chemicals beyond the tower.Dedicated drift eliminators change exhaust-air direction and capture entrained droplets.
Basin sediment blocks strainers and accelerates corrosion.Accessible sloped basin surfaces, drain points and removable strainers simplify routine cleaning.
Aplicações típicas
Cleanroom chiller condenser-water systemsPharmaceutical process-cooling loopsHospital central plantsElectronics-factory HVACIndustrial refrigeration heat rejection
Parâmetros técnicos
Representative physical construction ranges for a modular counterflow tower are listed below.
| Material principal | PVC fill media inside fiber-reinforced polymer casing |
|---|---|
| Painel de espessura | 3-6 mm molded FRP casing panel thickness |
| Largura efetiva | 1000-3200 mm nominal tower cell width |
| Comprimento máximo | Up to 6500 mm for multi-cell assemblies |
| Aço enfrentando espessura | 1.5-3.0 mm stainless or hot-dip-galvanized basin/support sheet |
| Densidade Core | 30-60 kg/m³ typical PVC fill-pack density |
| Condutividade térmica | Approximately 0.19 W/(m·K) for rigid PVC fill material |
| Superfície acabado | Smooth UV-stabilized FRP exterior with passivated or galvanized hardware |
| Tipo conjunto | Bolted gasketed casing panels with modular clipped fill cassettes and flanged water ports |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Single-cell or multi-cell configurationPVC or higher-temperature polypropylene fillVariable-speed fan drive and vibration switchStainless basin, electric basin heater and low-noise fan
Planning a Induced-Draft Counterflow Cooling Tower specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
