Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Filtros de ar e filtragem química
Filtro de escape HEPA Housing
A sealed wall or ceiling housing that captures contaminated room exhaust through a room-side replaceable HEPA filter before it enters the duct system.
- Negative-Pressure Service
- Room-Side Replacement
- Optional Prefilter Door
- Integrated Test Connections
Introdução do produto
The exhaust HEPA housing mounts at the room boundary so contaminated air crosses the filter before entering shared ductwork. A welded box, sealed inlet grille and compression clamp keep the dirty side confined to a shallow room-side zone. The front panel can include an integral prefilter and opens for filter replacement without disturbing the downstream duct. Pressure sampling, aerosol injection and scan access can be incorporated around the sealing frame.
Características-chave
Room-side filter access supports service where ceiling-void entry is restricted.
A hinged prefilter face intercepts lint and extends the life of the HEPA element.
Integrated test connections allow seal and resistance checks at the terminal.
Preocupações do produto do cliente
An exhaust terminal must prevent contaminated room air from bypassing into the common duct and remain serviceable under negative pressure.
Contaminants enter the duct before reaching a remote central filter.A terminal HEPA element captures particles at the room boundary.
Lint loads the HEPA face and raises room negative pressure.A removable coarse prefilter intercepts larger debris ahead of the absolute filter.
The sealing edge cannot be inspected from the occupied space.Room-side clamps expose the gasket or gel interface after the grille is removed.
Testing disturbs ductwork shared with adjacent rooms.Local pressure and aerosol ports keep verification focused on the individual terminal.
Aplicações típicas
Hospital isolation roomsMicrobiology laboratory exhaustPharmaceutical weighing boothsAnimal holding suitesControlled decontamination rooms
Parâmetros técnicos
Typical construction ranges for a room-side exhaust HEPA housing are shown below.
| Material principal | Fully welded galvanized or 304 stainless-steel box with stainless room-side filter clamp |
|---|---|
| Painel de espessura | 1.0–1.5 mm enclosure panels |
| Largura efetiva | 305–915 mm nominal filter face width |
| Comprimento máximo | Up to 1220 mm nominal terminal length |
| Aço enfrentando espessura | 1.0–1.5 mm housing and grille sheet |
| Densidade Core | Approximately 7850–8000 kg/m³ for steel housing parts |
| Condutividade térmica | Approximately 15–50 W/(m·K) for the selected exhaust-box sheet construction |
| Superfície acabado | White powder coat or brushed stainless finish with smooth cleanable face |
| Tipo conjunto | Welded terminal box with room-side gasket or gel filter seal and flanged exhaust spigot |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
Wall or ceiling mountingGasket- or gel-seal HEPAIntegral prefilter grillePressure and aerosol test ports
Planejamento de uma especificação de alojamento de filtro de escape HEPA?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
