English
Немецкий
Арабский язык
Французский
Индонезийский
Японский язык
Корейский
Японский
Португальский
Русский языкТекущий
Испанский язык
Тайский
Турецкий
Вьетнамский язык
Воздушные фильтры и химическая фильтрация
Корпус выхлопного фильтра HEPA
A sealed wall or ceiling housing that captures contaminated room exhaust through a room-side replaceable HEPA filter before it enters the duct system.
- Negative-Pressure Service
- Room-Side Replacement
- Optional Prefilter Door
- Integrated Test Connections
Введение продукции
The exhaust HEPA housing mounts at the room boundary so contaminated air crosses the filter before entering shared ductwork. A welded box, sealed inlet grille and compression clamp keep the dirty side confined to a shallow room-side zone. The front panel can include an integral prefilter and opens for filter replacement without disturbing the downstream duct. Pressure sampling, aerosol injection and scan access can be incorporated around the sealing frame.
Основные характеристики
Room-side filter access supports service where ceiling-void entry is restricted.
A hinged prefilter face intercepts lint and extends the life of the HEPA element.
Integrated test connections allow seal and resistance checks at the terminal.
Обеспокоенность клиентов продуктами
An exhaust terminal must prevent contaminated room air from bypassing into the common duct and remain serviceable under negative pressure.
Contaminants enter the duct before reaching a remote central filter.A terminal HEPA element captures particles at the room boundary.
Lint loads the HEPA face and raises room negative pressure.A removable coarse prefilter intercepts larger debris ahead of the absolute filter.
The sealing edge cannot be inspected from the occupied space.Room-side clamps expose the gasket or gel interface after the grille is removed.
Testing disturbs ductwork shared with adjacent rooms.Local pressure and aerosol ports keep verification focused on the individual terminal.
Типичные приложения
Hospital isolation roomsMicrobiology laboratory exhaustPharmaceutical weighing boothsAnimal holding suitesControlled decontamination rooms
Технические параметры
Typical construction ranges for a room-side exhaust HEPA housing are shown below.
| Основной материал | Fully welded galvanized or 304 stainless-steel box with stainless room-side filter clamp |
|---|---|
| Толщина панели | 1.0–1.5 mm enclosure panels |
| эффективная ширина | 305–915 mm nominal filter face width |
| Максимальная длина | Up to 1220 mm nominal terminal length |
| Толщина линий стали | 1.0–1.5 mm housing and grille sheet |
| Плотность ядра | Approximately 7850–8000 kg/m³ for steel housing parts |
| Теплопроводимость | Approximately 15–50 W/(m·K) for the selected exhaust-box sheet construction |
| Поверхностная отделка | White powder coat or brushed stainless finish with smooth cleanable face |
| Объединенный тип | Welded terminal box with room-side gasket or gel filter seal and flanged exhaust spigot |
| Customization | Доступно в зависимости от предполагаемого применения и операционной среды. |
Доступные варианты
Wall or ceiling mountingGasket- or gel-seal HEPAIntegral prefilter grillePressure and aerosol test ports
Planning a Exhaust HEPA Filter Housing specification?
Отправьте нам ваши габариты, условия монтажа, целевые показатели производительности и требуемую отделку поверхности.
