Inglês
Alemão
Língua árabe
Francês
Língua indonésia
Japonês
Coreano
Língua malaia
Portuguêsatual
Língua russa
Espanhol
Tailandês
Língua turca
Vietnã
Acessórios de instalação de sala limpa
Sala limpa Wall Sleeve
A double-flange stainless steel sleeve that forms a smooth, durable passage through cleanroom wall panels for pipes and services.
- Smooth Hollow Bore
- Double Hygienic Flange
- 304 Stainless Steel
- Panel-Edge Protection
Introdução do produto
The cleanroom wall sleeve is a rigid stainless tube with broad circular trim flanges at both ends. Installed through a prepared panel opening, it protects the exposed panel core and creates a smooth bore for routing a process pipe, conduit or service line. Continuous welded transitions and brushed surfaces simplify perimeter sealing and wipe-down on both room faces.
Características-chave
Two broad flanges cover the cut edges on both sides of the partition.
Smooth welded tube-to-flange transitions reduce dirt-catching ledges.
Sleeve diameter and barrel length can be matched to the service and panel thickness.
Preocupações do produto do cliente
A raw hole through an insulated cleanroom panel exposes core material and leaves an irregular perimeter that is difficult to seal and clean.
Cut panel edges release debris or absorb moisture around the penetration.The continuous metal barrel isolates the panel core from the service passage.
Irregular openings leave visible gaps around the pipe route.Broad end flanges cover the cut perimeter and provide consistent sealing faces.
Sharp panel skins can damage cables or small tubing.The smooth finished bore removes exposed sheet-metal edges from the passage.
Fixed stock lengths do not match different wall build-ups.Sleeve length is produced to suit the panel thickness and finish allowance.
Aplicações típicas
Process-pipe wall passagesClean utility conduitsElectrical service penetrationsInstrument tubing routesHygienic panel openings
Parâmetros técnicos
Typical construction ranges for a double-flange stainless cleanroom wall sleeve are listed below.
| Material principal | 304 or 316L stainless-steel tubular sleeve with welded circular flanges |
|---|---|
| Painel de espessura | 40-200 mm compatible partition thickness |
| Largura efetiva | 25-300 mm clear internal bore diameter |
| Comprimento máximo | Up to 1000 mm sleeve barrel length |
| Aço enfrentando espessura | 1.00-3.00 mm tube wall and flange fabrication thickness |
| Densidade Core | Approximately 7900-8000 kg/m³ for stainless steel |
| Condutividade térmica | Approximately 14-17 W/(m·K) for austenitic stainless steel |
| Superfície acabado | Brushed, satin-polished or electropolished stainless-steel surfaces |
| Tipo conjunto | Through-panel sleeve with welded double trim flanges and sealed perimeter |
| Customização | Disponível com base na aplicação pretendida e no ambiente operacional. |
Opções disponíveis
304 or 316L stainless steelCustom bore diameterFixed or split trim flangeBrushed or electropolished finish
Planning a Cleanroom Wall Sleeve specification?
Envie-nos as suas dimensões, condições de instalação, metas de desempenho e acabamento de superfície necessário.
