Three-quarter view of a double-flange stainless cleanroom wall sleeve

クリーンルームの設置付属品

クリーンルームの壁のスリーブ

A double-flange stainless steel sleeve that forms a smooth, durable passage through cleanroom wall panels for pipes and services.

Smooth Hollow Bore
Double Hygienic Flange
304 Stainless Steel
Panel-Edge Protection

見積もりリクエスト製品案内

商品紹介

The cleanroom wall sleeve is a rigid stainless tube with broad circular trim flanges at both ends. Installed through a prepared panel opening, it protects the exposed panel core and creates a smooth bore for routing a process pipe, conduit or service line. Continuous welded transitions and brushed surfaces simplify perimeter sealing and wipe-down on both room faces.

主要な特徴

A continuous stainless bore isolates the service opening from the exposed panel core.

Two broad flanges cover the cut edges on both sides of the partition.

Smooth welded tube-to-flange transitions reduce dirt-catching ledges.

Sleeve diameter and barrel length can be matched to the service and panel thickness.

お客様の製品に関する懸念事項

A raw hole through an insulated cleanroom panel exposes core material and leaves an irregular perimeter that is difficult to seal and clean.

Cut panel edges release debris or absorb moisture around the penetration.The continuous metal barrel isolates the panel core from the service passage.

Irregular openings leave visible gaps around the pipe route.Broad end flanges cover the cut perimeter and provide consistent sealing faces.

Sharp panel skins can damage cables or small tubing.The smooth finished bore removes exposed sheet-metal edges from the passage.

Fixed stock lengths do not match different wall build-ups.Sleeve length is produced to suit the panel thickness and finish allowance.

典型的な用途

Process-pipe wall passagesClean utility conduitsElectrical service penetrationsInstrument tubing routesHygienic panel openings

技術的なパラメータ

Typical construction ranges for a double-flange stainless cleanroom wall sleeve are listed below.

コア材料	304 or 316L stainless-steel tubular sleeve with welded circular flanges
パネルの厚さ	40-200 mm compatible partition thickness
有効幅	25-300 mm clear internal bore diameter
最大長さ	Up to 1000 mm sleeve barrel length
鋼鉄の厚さを直面する	1.00-3.00 mm tube wall and flange fabrication thickness
コア密度	Approximately 7900-8000 kg/m³ for stainless steel
熱伝導率	Approximately 14-17 W/(m·K) for austenitic stainless steel
表面仕上げ	Brushed, satin-polished or electropolished stainless-steel surfaces
ジョイントタイプ	Through-panel sleeve with welded double trim flanges and sealed perimeter
カスタマイズ	意図したアプリケーションと動作環境に基づいて利用できます。

利用可能なオプション

304 or 316L stainless steelCustom bore diameterFixed or split trim flangeBrushed or electropolished finish

Planning a Cleanroom Wall Sleeve specification?

寸法、設置条件、性能目標、必要な表面仕上げをお送りください。

チームに相談する